Bedienungsanleitung Trotec PTNS10-20V (Seite 9 von 17) (Englisch)

753360

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

EN 9

cordless tacker PTNS 10-20V

– Only ship batteries if their housing is undamaged.

– Mask open terminals with tape and pack the battery in

a way that it cannot move inside the packaging.

– Please also observe any other national regulations.

Storage

Before storing the device, observe the following:

• Switch off the device.

• Hold onto the mains plug while pulling the power cable of

the charger out of the mains socket.

• Allow the device to cool down.

• Remove the battery from the device.

• Clean the device as described in the Maintenance chapter.

• For storing the device, use the transport case included in

the scope of delivery in order to protect the device from

external influences.

• Do not store Li-ion batteries which are completely

discharged. Storing discharged batteries can lead to a

deep discharge and thus damage the battery.

When the device is not being used, observe the following

storage conditions:

• Dry and protected from frost and heat

• Ambient temperature below 45°C

• Protected from dust and direct sunlight inside the transport

case

Start-up

Unpacking the device

• Take the device and the accessories out of the packaging.

Warning of electrical voltage

Electric shock from insufficient insulation.

Check the device for damages and proper functioning

before each use.

If you notice damages, no longer use the device.

Do not use the device when the device or your hands

are damp or wet!

• Check the scope of delivery for completeness and look for

damages.

Warning

Risk of suffocation!

Do not leave the packaging lying around. Children may

use it as a dangerous toy.

• Dispose of the packaging material according to the

national regulations.

Charging the battery

Note

The battery can be damaged in case of improper

charging.

Remove the charger's mains plug before inserting or

removing the battery.

Never charge the battery at ambient temperatures

below 10°C or above 40°C.

The battery is partially charged upon delivery to avoid damage

to the battery caused by a deep discharge.

Prior to initial start-up and when the battery is low (only the red

LED in the battery level indication(12) is illuminated), the

battery should be charged. To do so, please proceed as follows:

1. Slide the battery(9) onto the quick charger(7) upside

down until it locks in place.

1 h

2. Insert the mains plug of the quick charger(7) into a

properly fused mains socket.

ðThe red battery LED(8) lights up.

ðCharging requires approx. one hour.

3. Wait until the red battery LED(8) goes off and the green

battery LED(14) lights up.

ðThe battery(9) is fully charged.

4. Hold onto the mains plug while pulling the power cable of

the quick charger(7) out of the mains socket.

ðThe battery(9) and the quick charger(7) may have

become warm during charging.

Allow the battery(9) to cool down to room temperature.

5. Take the battery(9) out of the quick charger(7) by

pressing and holding the release button(13) and pulling

the battery(9) off the quick charger(7).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PTNS10-20V Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PTNS10-20V

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info