753360
12
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
12 EN
cordless tacker PTNS 10-20V
Impact force preselection
The impact force can be adjusted according to the material by
using the impact force regulator(16). If the impact force is set
too high, there is a risk that the material to be attached will be
pierced. If the impact force is set too low, the staples cannot
penetrate the material deeply enough and will not be attached
properly.
The required impact force depends on the material and can be
determined by way of field-testing. To do this, ideally use some
excess material residues. Always use the lowest impact force
required for entirely injecting the staple.
The setting range is between stages1– 6. Stage1 refers to the
lowest impact force, stage6 to the highest. You can change the
impact force which you have preselected at any time.
1. Turn the regulator(16) to the desired stage.
16
Operation
Tips and notes on handling the tacker
Warning of sharp object
Wire nails and staples are sharp. Risk of injuries if
handled without due care!
General information:
Always apply the device to the workpiece firmly and at a
right angle. Otherwise the staple or wire nail could be
diverted sideways.
Be careful when using the device on soft workpieces. Else
the workpiece could be damaged.
Observe the size of staples and wire nails as specified in
the technical data.
At the magazine filling level indicator you can check
whether any staples or wire nails are left in the magazine.
Always remove the battery from the device when a staple
or wire nail is jammed inside! The trigger could be
actuated by accident while removing a jammed staple or
wire nail.
The trigger(2) is linked to the movable tacker guide
nose(5) and will only trigger if the tacker guide nose is
pushed on the workpiece. It makes sure that a shot cannot
be released accidentally just by inadvertently pulling the
trigger.
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Trotec PTNS10-20V wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Trotec PTNS10-20V

Trotec PTNS10-20V Bedienungsanleitung - Deutsch - 18 seiten

Trotec PTNS10-20V Bedienungsanleitung - Holländisch - 17 seiten

Trotec PTNS10-20V Bedienungsanleitung - Französisch - 18 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info