Bedienungsanleitung Trotec TTK68E (Seite 9 von 20) (Englisch)

753264

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

EN 8

Operating manual – dehumidifier TTK 68 E / TTK 69 E

5. Push one end of the hose onto the hose adapter.

6. Guide the other hose end to a suitable drain or sufficiently

dimensioned collection container. Please observe that the

hose must not be kinked.

Setting the fan stage

The following fan stages can be selected:

•High: highest fan stage

•Med: medium fan stage

•Low: lowest fan stage

1. Press the Fan button (21) until the LED for the desired stage

lights up.

Setting the timer

The timer can be adjusted in increments of 1hour to a value

between 0 and 24hours.

Preselecting the switch-on time:

1. Press the Timer button(18) to switch on the timer.

2. Press the Timer button(18) until the desired number of

hours until automatic switch-on has been set.

ðThe number of hours is indicated on the display for

approx.5s.

ðThe device switches on after the predefined time.

Preselecting the switch-off time:

üThe device is switched on already.

1. Press the Timer button(18) to activate the timer.

2. Press the Timer button(18) until the desired number of

hours has been set.

ðThe number of hours is indicated on the display for

approx.5s.

ðThe device switches off after the predefined time.

Automatic defrost

At low ambient temperatures the evaporator can freeze up

during dehumidification. The device then carries out an

automatic defrost. The duration of the defrost process can vary.

Do not switch off the device during automatic defrost. Do not

remove the mains plug from the mains socket.

Memory function

In case of brief power failures the device memorizes the set fan

stage and operating mode. The pre-programmed start and stop

times for automatic operation are not saved.

Child lock

To deactivate child lock, please proceed as follows:

1. Simultaneously press both buttons Mode(20) and

Timer(18) for approx. 1s.

ðChild lock is activated.

ðThe message LC will be indicated on the display

whenever a button is pressed.

2. Press the buttons Mode(20) and Timer(18) again for

approx. 1s to deactivate the lock.

ðAll buttons can be actuated once again.

Auto stop function

If the water tank is full, not inserted correctly or if the humidity

level is 5% lower than the set humidity value, the device stops

automatically.

Shutdown

1. Press the ON/OFF button(17).

Danger!

Do not touch the mains plug with wet or damp hands.

2. Remove the mains plug from the mains socket.

3. If necessary, remove the condensation drain hose and any

residual fluid from it.

4. If necessary, empty the condensation tank and wipe it dry

with a clean cloth. Check for dripping condensation.

5. Clean the device, and especially the air filter, according to

the chapter Maintenance.

6. Store the device according to the chapter Storage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec TTK68E Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec TTK68E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info