Bedienungsanleitung Trotec TTK68E (Seite 10 von 20) (Englisch)

753264

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

9 EN

Operating manual – dehumidifier TTK 68 E / TTK 69 E

Errors and faults

The device has been checked for proper functioning several

times during production. If malfunctions occur nonetheless,

check the device according to the following list.

Note:

Wait for at least 3 minutes after maintenance and repair work.

Only then switch the device back on.

The device does not start:

• Check the power connection.

• Check the mains plug for damages.

• Check the condensation tank for correct seating. Check the

filling level of the condensation tank and empty it, if

necessary. The indicator lightmust not light up.

• Wait for 10 minutes before restarting the device. If the

device is not starting, have the electrics checked by a

specialist company or by Trotec.

The device is running, but no condensate forms:

• Check the float in the condensation tank for dirt. If

necessary, clean the condensation tank. The float must be

able to move freely.

• Check the room temperature. Observe the device's

permissible operating range according to the technical

data.

• Check the air filter for dirt. If necessary, clean or replace

the air filter.

• From the outside, check the condenser for dirt (see

chapter Maintenance). If your condenser is dirty, have it

cleaned by a specialist company or by Trotec.

The device is loud or vibrates; condensate is leaking:

• Check whether the device is standing upright and on an

even surface.

The device gets very warm, is loud or loses power:

• Check the air inlets and air filter for dirt. Remove external

dirt.

• From the outside, check the device for dirt (see chapter

Maintenance). If the inside of the device is dirty, have it

cleaned by a specialist company or by Trotec.

Your device still does not operate correctly after these

checks?

Have the device repaired by authorised expert staff or by Trotec.

Maintenance

Activities required before starting maintenance

• Do not touch the mains plug with wet or damp hands.

• Before any work, remove the mains plug!

Danger!

Maintenance tasks which require the housing to be

opened must only be carried out by authorised

specialist companies or by Trotec.

Visual inspection of the inside of the device for dirt

1. Remove the air filter.

2. Use a torch to illuminate the openings of the device.

3. If you see a thick layer of dust, have the inside of the device

cleaned by a specialist company for cooling and air-

conditioning or by Trotec.

4. Put the air filter back in.

Cleaning the housing

Clean the device with a soft, damp and lint-free cloth. Ensure

that no moisture enters the housing. Do not use abrasive

cleaners.

Refrigerant circuit

• The entire refrigerant circuit is a maintenance-free,

hermetically sealed system and may only be maintained or

repaired by specialist companies for cooling and air-

conditioning or by Trotec.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec TTK68E Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec TTK68E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info