Bedienungsanleitung Truma Elektroboiler (Seite 6 von 24) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch)

489381

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Switching on

Boiler EL

230 V ~

c = Rocker switch “Off”

d = Rocker switch “On”

Switch the boiler on at the control panel (c). The indicator

lamp indicates that the device is in operation.

When using the vehicle switches: refer to operating instruc-

tions of the vehicle manufacturer.

The water temperature cannot be selected, automatic

temperature limitation at approx. 70 °C.

The electrical heating rod is fitted with an excess temper-

ature cut-out.If the device is operated without water, the

overtemperature protection switches it off at 90 °C. In order to

switch the device on again, allow it to cool to below 24 °C,

switch “Off” and switch “On” again (Reset).

Maintenance

Always use original Truma parts for maintenance and

repair work!

Use wine vinegar for de-scaling the water heater, this being

introduced into the appliance via the water supply. Allow the

product to react and then thoroughly flush out the appliance

with plenty of fresh water. To sterilise the water we recom-

mend “Certisil-Argento”. Other products, particularly those

containing chlorine are unsuitable.

To avoid infestation by micro-organisms, the boiler must be

heated to 70 °C at regular intervals.

Disposal

The device must be disposed of in line with the administra-

tive regulations of the respective land in which it is used.

National regulations and laws (in Germany, for example,

the Altfahrzeug-Verordnung [old vehicle directive]) must be

observed.

Trouble-shooting list

Fault Cause Rectification

The water does not become

warm.

– No operating voltage.

– Operation without water;

over-temperature fuse cuts

off the heating element.

– Restore power supply.

– Switch off, wait 10 minutes, fill with water, switch on.

Water taking an extremely

long time to heat up.

– Water container furred. – Descale water system (see maintenance).

Water running out, cannot fill

boiler.

– Safety/drain valve open. – Close safety/drain valve.

Cannot empty boiler, even

though safety/drain valve

is open.

Water dripping from draining

connection of safety/drain

valve.

– Safety/drain valve draining

connection blocked.

– Venting hose is closed.

– The elbow connection on

the boiler is twisted.

– Water pressure too high.

– Check opening for soiling (slush, ice, leaves etc.) and

remove if necessary.

– Check opening (see above).

– Check hose for kinks and remedy.

– The venting hose on the elbow connection needs

to point upwards.

– Check pump pressure (max. 2.8 bar). If connected to a

central water supply (rural or urban connection), a pressure

reducer must be used, which will prevent pressures higher

than 2.8 bar entering the boiler.

If these measures do not remove the failure, please contact the Truma Service Centre.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Truma Elektroboiler Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Truma Elektroboiler

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info