Bedienungsanleitung Truma Mover XT 4 (Seite 16 von 88) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Schwedisch)

590216

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

General instructions

The Mover®XT4 has been designed to cope with inclines of

up to approx. 10 % bearing a gross weight of 3100 kg on a

suitable surface.

Depending on the weight of the caravan, the Mover®XT4

may not be able to overcome obstacles more than about

5 cm in height without auxiliary equipment (please use ascent

chocks).

As a result of the characteristic properties of a radio signal, it

may be interrupted by terrain / objects. This reduces reception

quality in small areas around the caravan, as a result of which

the operation of the Mover®XT4 may be briefly interrupted.

When the Mover®XT4 is switched off using the remote

control, the control unit remains in standby for one hour.

In order to switch off completely the battery must be discon-

nected or an isolating switch installed.

Batteries

For optimum operation we recommend the Truma Mover®

PowerSet, which contains batteries with button cells and an

appropriate charger. So-called drive, lighting and gel batteries

with sufficient capacity are also suitable.

Recommended battery capacities

Button cell technology at least 55 Ah

Gel / AGM at least 70 Ah

Lead-acid battery (liquid electrolyte) at least 80 Ah

Starter batteries are not suitable

Batteries with greater capacity allow the equipment to

be used for longer.

Charger

For optimum battery charging we recommend the Truma BC 10

charger, which is suitable for all battery types up to 200 Ah.

Battery care (including maintenance-free

batteries)

In order to achieve a long battery service life, attention must

be paid to the following points:

– Batteries should be fully charged before and after removing

power,

– for stationary periods of longer than 24 hours, interrupt

power circuit (e.g. using circuit breaker or by disconnecting

the battery poles),

– for longer stop periods the battery must be disconnected

and charged for 24 hours at least every 12 weeks.

In winter, store fully charged battery in a cool and frost-free

place and recharge at regular intervals (every 12 weeks).

Function description

Always observe the operating instructions and the

“Safety instructions” prior to starting! The vehicle owner

is responsible for correct operation of the device.

Please note that the Mover®XT4 is only suitable for

twin-axle trailers.

The Mover®XT4 is a manoeuvring system which allows a cara-

van to be manoeuvred without the aid of the towing vehicle.

It consists of four separate drive assemblies, each with its

own 12V DC motor. These units are mounted on the frame

of the vehicle in the immediate vicinity of the wheels, and are

connected by a lateral bar.

Once the drive rollers have been engaged using the remote

control, the Mover®XT4 is ready for operation. It is operated

exclusively via the remote control, which transmits radio sig-

nals to the control unit. A separately installed 12V lead-acid

battery or suitable lead-gel battery (not supplied) provides the

control unit with electrical power.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Truma Mover XT 4 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info