Bedienungsanleitung Trumatic S 5004 (Seite 8 von 48) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch)

484598

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Table of contents

Symbols used ......................................................................... 8

Safety instructions ............................................................. 8

Important operating notes ................................................ 9

Intended use ........................................................................... 9

Operating instructions

S 3004 / S 3004 P heating system ....................................... 10

S 5004 heating system ........................................................ 10

Taking into operation ....................................................... 10

S 3004 P with Piezo push ignitor ......................................... 10

S 3004 / S 5004 with auto ignitor ........................................ 10

Operating the fan ................................................................. 11

Lighting ................................................................................ 11

Room thermostat ................................................................. 11

Switching off ..................................................................... 11

Maintenance ...................................................................... 11

Cleaning (only with the device switched off!) ...................... 11

Remove cover ...................................................................... 11

Attach cover ......................................................................... 12

Battery change on the auto ignitor ...................................... 12

Specific information ......................................................... 12

Disposal .............................................................................. 12

Technical data .................................................................... 12

Dimensions .......................................................................... 12

Declaration of conformity ............................................... 13

Manufacturer’s terms of warranty ................................ 13

S 3004 / S 3004 P / S 5004

Symbols used

Symbol indicates a possible hazard.

Risk of burns! Hot surface.

Wear protective gloves to protect against possible

mechanical injuries.

Observe the ESD-regulations! An electro-static charge

can destroy the electronics. Ensure potential equalisa-

tion before touching the electronics.

Comment including information and tips.

Safety instructions

An opened skylight / lifting roof around the exhaust cowl in-

volves the danger of exhaust gas entering the vehicle interior.

The heater may only be operated when the roof skylight /

lifting roof is closed.

The use of upright gas cylinders from which gas is taken in

the gas phase is mandatory for the operation of gas regula-

tors, gas equipment and gas systems. Gas cylinders from

which gas is taken in the liquid phase (e.g. for fork lifts)

must not be used, since they would result in damage to the

gas system.

In case of gas system leaks or gas smell:

Put out all naked flames

Do not smoke

Switch off gas equipment

Close gas cylinders

Open windows and doors

Do not use any electrical switches

Allow the whole system to be checked by an expert!

Only experts may carry out repair work!

A new O-ring must be mounted each time the waste gas line

is dismantled.

Guarantee claims, warranty claims and acceptance of liability

will be ruled out in the event of the following:

modifications to the unit (including accessories),

modifications to the exhaust duct and the cowl,

failure to use original Truma parts as replacement parts

and accessories,

failure to follow the installation and operating instructions.

It also becomes illegal to use the appliance, and in some

countries this even makes it illegal to use the vehicle.

The gas supply’s operating pressure (30 mbar) must be the

same as the unit´s operating pressure (see type plate).

Liquid gas systems must comply with the technical and ad-

ministrative provisions of the respective country in which it

is used (e.g. EN 1949 for vehicles). National instructions and

regulations (e.g. the DVGW work sheet G 607 in Germany)

must be observed.

The inspection of the gas system must be repeated in Ger-

many every 2 years by a liquid gas specialist (DVFG, TÜV,

DEKRA). It must be confirmed on the inspection certificate

according to DVGW work sheet G 607.

The vehicle owner is responsible for arranging inspection.

Liquid gas devices may not be used while refuelling, in multi-

storey car parks, garages or on ferries.

Slight development of smoke and odours can occur when

commissioning a new factory device (or after a longer period

out of use). It is appropriate to immediately allow the device to

burn on the highest power and ensure good ventilation of the

room.

An unusual burner noise or raising of the flame points to a

controller defect and makes an inspection of the controller

necessary.

Heat sensitive objects (e.g. spray cans) may not be stored in

the heating installation area as high temperatures can occur.

For the gas system, only pressure controller devices accord-

ing to EN 12864 (in vehicles) with a fixed output pressure of

30 mbar may be used. The flow rate of the pressure controller

device must correspond with the highest consumption of all

installed devices as a minimum.

–

Trumatic S 5004 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info