Bedienungsanleitung Turbionaire Smart 14eco (Seite 8 von 126) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

804594

Zoom out

Zoom in

Vorherige Seite

1/126

Nächste Seite

protected materials against corrosion.

9. Checking electrical devices

The repair and the maintenance of electrical components must include initial safety checks

and component inspection procedures. If there is a failure that could compromise the safety,

the circuit must not be connected to any power source until the failure is treated

satisfactorily. If the failure cannot be corrected immediately, but operating is still necessary,

an appropriate temporary solution should be used. This must be reported to the owner of

the equipment so that all parties are informed. The initial safety checks shall be carried out

if:

-capacitors are discharged: this is done in a safe manner to avoid the occurrence of

sparks;

-electrical components and electrical cables are not exposed during charging,

refurbishing or cleaning the plant;

-there is grounding continuity.

10.Repair of sealed items

While sealed items are being repaired, all power sources must be disconnected from the

equipment it must be intervened on, before any removal of the sealed caps, etc. If it is

absolutely necessary to power the equipment during service, then a continuous leakage

detection system should be considered at the most critical point to warn in case of a

potentially hazardous situation.

Particular attention must be paid to the following aspects in order to ensure that while

working on the electrical components, the housing is not modified in such a way that the

protection level is affected. These include cable damage, excessive number of connections,

terminals which do not comply with the original specifications, seals damage, improper

seals fitting, etc.

Ensure that the appliance is safely mounted. Ensure that the seals or the sealing materials

are not degraded so that they are no longer used for the purpose of preventing the

penetration of flammable gases. Spare parts must be in accordance with the specifications

of the manufacturer.

11.Repairs brought to intrinsically safe components

Do not use permanent inductive or capacitive loads in the circuit without ensuring that they

do not exceed the voltage and power allowed for the equipment used. The intrinsically

safe components are the only types it can be worked on in the presence of a flammable

atmosphere. The test appliance must be correctly evaluated. Replace the components only

with the parts specified by the manufacturer. Other components may cause the ignition of

the refrigerant in the atmosphere due to a leakage.

12. Cables

Check that the cables will not be subjected to wear, corrosion, excessive pressure, vibrations,

sharp edges or other adverse effects on the environment. Verification should also take into

account the effects of the deterioration over time or of the continuous vibrations from

sources such as compressors or fans.

13. Detection of flammable refrigerants

Potential sources of ignition should not be used under any circumstances when searching or

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Turbionaire Smart 14eco Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info