Bedienungsanleitung Unify OpenScape Desk Phone CP600E (Seite 159 von 190) (Englisch)

680296

159

Zoom out

Zoom in

Vorherige Seite

1/190

Nächste Seite

administration.fm

A31003-C1000-M102-9-76A9, 08/2018

OpenScape Desk Phone CP100/200/CP205/CP400/CP600/600E HFA, Administration Manual

159

Administration

Diagnostics

3.20.5.2 View Session Data

OpenScape Desk Phone CP phones generate QoS reports using a HiPath specific format,

QDC (QoS Data Collection). The reports created for the last 6 sessions, i. e. conversations, can

be viewed on the WBM.

To enable the generation of reports, please ensure that:

• the switch QoS traps to QCU (System > SNMP) is activated (see Section 3.3.8, “SNMP”);

• the conditions for the generation of reports are set adequately (see Section 3.20.5.1, “Con-

ditions and Thresholds for Report Generation”).

For details about QoS reports on OpenScape Desk Phone CP devices, see the HiPath QoS

Data Collection V 1.0 Service Manual.

A QoS report contains the following data:

• Start of report period - seconds: NTP time in seconds for the start of the report period.

• Start of report period - fraction of seconds: Additional split seconds to be added to the

seconds for an exact start time.

• End of report period - seconds: NTP time in seconds for the end of the report period.

• End of report period - fraction of seconds: Additional split seconds to be added to the

seconds for an exact end time.

• SNMP specific trap type: The trap type is a 5 bit value calculated from a list of threshold-

exceeding bits. Every time a threshold is exceeded, the associated bit is set, otherwise it

is cleared.

The trace type bits are defined as follows:

• Bit 0: Jitter threshold was exceeded.

• Bit 1: Delay threshold was exceeded.

• Bit 2: Threshold for lost packets was exceeded.

• Bit 3: Threshold for consecutive lost packets was exceeded.

• Bit 4: Threshold for consecutive good packets was exceeded.

• IP address (local): IP address of the local phone.

• Port number (local): RTP receiving port of the local phone.

• IP address (remote): IP address of the remote phone that took part in the session.

• Port number (remote): RTP sending port of the local phone.

• SSRC (receiving): RTP Source Synchronization Identifier of the local phone.

• SSRC (sending): RTP Source Synchronization Identifier of the remote phone.

• Codec: Number of the Payload Type applied in the session; see RFC 3551 (Table 4 and 5).

• Maximum packet size: Maximum size (in ms) of packets received during the report inter-

val.

• Silence suppression: Number of silence suppression activation objects found in the RTP

stream received. A silence suppression activation object is defined as a period of silence

when no encoded voice signals were transmitted by the sender.

• Count of good packets: Total amount of good packets.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Unify OpenScape Desk Phone CP600E Seite 159

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Unify OpenScape Desk Phone CP600E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info