Bedienungsanleitung Unify OpenScape Desk Phone CP600E (Seite 160 von 190) (Englisch)

680296

160

Zoom out

Zoom in

Vorherige Seite

1/190

Nächste Seite

Administration

A31003-C1000-M102-9-76A9, 08/2018

160 OpenScape Desk Phone CP100/200/CP205/CP400/CP600/600E HFA, Administration Manual

administration.fm

Diagnostics

• Maximum jitter: Maximum jitter (in ms) found during the report interval.

• Maximum inter-arrival jitter: Maximum of the interarrival jitter values (in ms). The interar-

rival jitter is the smoothed absolute value of the jitter measurements. It is calculated con-

tinuously. For details about the calulation, see RFC 3550.

• Periods jitter threshold exceeded: Number of observation intervals in which the

threshold for maximum jitter was exceeded.

• Round trip delay: Average value of delay calculated for each RTCP packet. The first value

is available after about 15 sec.

• Round trip delay threshold exceeded: Set to "true" if the average round trip delay

threshold value was exceeded in the report interval.

• Count of lost packets: Number of packets lost in the course of speech decoding.

• Count of discarded packets: Number of the packets discarded without transferring the

contents.

• Periods of lost packets: Number of observation intervals in which the threshold for lost

packets was exceeded.

• Consecutive packet loss (CPL): List of sequences consecutive packets that were all lost,

grouped according to the amount of packets per sequence. The first number in the list

counts single lost packets, the second number counts sequences of two lost packets, and

so on. The last number counts sequences of more than 10 lost packets.

• Periods of consecutive lost packets: Number of observation intervals in which the

threshold for consecutive lost packets was exceeded.

• Consecutive good packets (CGP): List of sequences consecutive packets that were all

processed, grouped according to the amount of packets per sequence. The first number in

the list counts single good packets, the second number counts sequences of two good

packets, and so on. The last number counts sequences of more than 10 good packets. All

values are reset to 0 after an interval without packet loss.

• Periods of consecutive good packets: Number of intervals in which the count of lost

packets went below the threshold.

• Count of jitter buffer overruns: Number of packets rejected because the jitter buffer was

full.

• Count of jitter buffer under-runs: Increased by one whenever the decoder requests new

information on decoding and finds an empty jitter buffer.

• Codec change on the fly: The value is 1, if there has been a codec or SSRC change

during the observation period, and 0, if there has been no change.

• Periods with at least one threshold exceeded: Number of observation intervals with at

least one threshold exceedance. If there is no data, the value is 255. The threshold values

included are:

• maximum jitter;

• lost packets;

• consecutive lost packets;

• consecutive good packets.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Unify OpenScape Desk Phone CP600E Seite 160

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Unify OpenScape Desk Phone CP600E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info