Bedienungsanleitung V-Zug DW-S9 (Seite 16 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

503581

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

hood is to be xed.

• Fixing the decorative telescopic ﬂue:

-Arrange the electrical power supply within the dimensions

of the decorative ue. If your appliance is to be installed inthe

ducting version orin the version with externalmotor, prepare

the air exhaust opening.

-Adjust the width of the support bracket of the upper ue

(Fig.3).

-Then x it to the ceiling using the screws A (Fig.3) in such a

waythat itisin line withyourhoodandrespectingthe distance

from the ceiling indicated in Fig.2.

-Connect the ange Cto the air exhaust hole using a connec-

tion pipe (Fig.4).

-Insert the upper ue into the lower ue.

-Fix the lower ue to the hood using the screws B provided

(Fig.4), extract the upper ue up to the bracket and x it with

the screws B (Fig.3).

-To transform the hood from a ducting version into a ltering

version, ask your dealer for the charcoal lters and follow the

installation instructions.

• Filter hood:

Please note:

In order to transform the hood from EXTRACTOR HOOD

into FILTER HOOD the carbon lters must be ordered at your

distributor as accessory.

-To replace the extractable active carbon filters X, pull lever

outwards as shown in Fig.6.

-Therearetwo typesofcharcoallters: regenerable (washable)

(Fig.7) and non-regenerable (Fig.6).

USE AND MAINTENANCE

• We recommend that the cooker hood is switched on before

any food is cooked.We also recommend that the appliance is

left running for 15 minutes after the food is cooked, in order

to thoroughly eliminate all contaminated air.

The eective performance of the cooker hood depends on

constant maintenance; the anti-grease lter and the active

carbon lter both require special attention.

• The anti-grease ﬁlter is responsible retaining the grease

particles suspended in the air, therefore it is subject to

clogging with variable frequency according to the use of the

appliance.

- To prevent the danger of possible res, at least every 2

months one must wash the anti-grease lters by hand using

non-abrasive neutral liquid detergents or in the dishwasher

at low temperatures and on short cycles.

- After a few washes, colour alterations may occur. This does

not give the right to claim their replacement.

• The active carbon ﬁlters are used to purify the air that is

sent back into the room and its function s to mitigate the

unpleasant odours produced by cooking.

- The non-regenerable active carbon lters must be replaced

at least every 4 months. The saturation of the active charcoal

depends on the more or less prolonged use of the appliance,

on the type of kitchen and on the frequency with which anti-

grease lter is cleaned.

- Regenerable active charcoalltersmust bewashed by hand,

with non abrasive neutral detergents, or in the dishwasher at

a maximum temperature of 65°C (the washing cycle must be

complete without dishware). Remove excess water without

damaging the lter, remove the plastic parts, and let the mat

dry in the oven for at least 15 minutes approximately at a

maximum temperature of 100°C. To keep the regenerable

charcoal lter functioning ecient this operation must be

repeated every 2 months. These must be replaced at least

every 3 years or when the mat is damaged.

• Before remounting the anti-grease ﬁlters and the rege-

nerableactive charcoal lters itis important that they are

completely dry.

• Clean the hood frequently, both internally and externally,

using a cloth dampened with denatured alcohol or neutral

liquid detergents that are non abrasive.

• The lighting .system is designed for use during cooking

and not for the prolonged general lighting of the room. The

prolonged use of the lighting system signicantly decreases

the average duration of the bulbs.

• Attention: The non compliance with the hood cleaning

warnings and with the replacement andcleaning of the lters

entailsrisk ofres. One therefore recommends keeping tothe

suggested instructions.

• Replacing halogen light bulbs (Fig.8):

To replace the halogen light bulbs B, remove the glass panel

C using a lever action on the relevant cracks.

Replace the bulbs with new ones of the same type.

Caution: Do not touch the light bulb with bare hands.

• Commands (Fig.9):

The key symbols are explained below:

A = LIGHT

B = OFF

C = SPEED I

D= SPEED II

E = SPEED III

F = AUTOMATIC STOP TIMER - 15 minutes (*)

• If your appliance does not have the INTENSIVE speed

function, press key E for two seconds and it will be activated

for 10 minutes after which it will return to the previously set

speed.

When the function is active the LED ashes. To interrupt it

before the 10 minutes have expired press key E again.

• Clean Air:

By pressing key F for two seconds (with the hood switched

o) the “clean air” function is activated.

This function switches the appliance onfor tenminutes every

hour at the rst speed.

As soon as this function isactivated themotor starts upat the

rst speed for ten minutes.

During this time key F and key C must ash at the same time.

After ten minutes the motor switches o and the LED of key

F remains switchedon with axed light until the motor starts

up again at the rst speed after fty minutes and keys F and

C start to ash again for ten minutes and so on.

By pressing any key for the exclusion of the hood light the

hood will return immediately to its normal functioning (e.g.

if key D is pressed the “clean air” function is deactivated and

the motor moves to the 2nd speed straight away.

By pressing key B the function is deactivated).

(*) The “AUTOMATIC STOP TIMER” delays stopping of the

hood, which will continue functioning for 15 minutes at the

operating speed set at the time this function is activated.

• Anti-grease and active c arbon ﬁlters saturation:

-After 30 hours of work, the key A ashes every 2 sec.; in that

event,the anti-greaseandactivecarbon ltermustbe cleaned,

if present.

-After 120 hours of work, the key A ashes every 0.5 sec.; in

- 16 -

V-Zug DW-S9 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info