POWDPG80460 EN
Copyright © 2021 VARO P a g e | 6 www.varo.com
5.5 Service
▪ Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 ADDITIONAL SAFETY INSTRUCTIONS FOR SPRAYER
▪ Never spray at people. Never aim the nozzle at another person or animal. Never allow the
spray to come into direct contact with the skin.
▪ This spray gun must not be used for spraying flammable paints and solvents with a flash
point of less than 21°C.
▪ Always make sure that there is adequate ventilation in the work area when spraying.
▪ Always keep the spray basket nozzle in place during use.
▪ Do not use spray guns where there is a risk of fire or explosion.
▪ Be aware of any hazard by the material being sprayed and consult the markings on the
container or the information supplied by the manufacturer.
▪ Do not spray any material where the hazard is not known.
▪ Always use appropriate eye protection to keep hazardous vapors or fumes out of the eyes.
▪ Never operate a spray gun without wearing a face mask.
▪ Wear ear protector if the sound pressure exceeds 85dB(A).
▪ Keep your spray gun, paint container and nozzles clean. Do not clean with flammable
liquids with a flash point less than 21°C. Inspect the mains leas periodically and if
damaged have it replaced by a qualified person.
▪ Never spray near a naked flame or appliance pilot flame.
▪ Never smoke whilst spraying.
▪ Always read the paint manufacturers thinning recommendations or instructions before
using pain or other materials.
▪ Always disconnect from the mains supply when filling the paint container or cleaning the
spray gun.
▪ Avoid running the unit with the flow rate knob fully closed for any length of time.
▪ Never allow children, persons with reduced physical, sensory, or mental capabilities or
lack of experience and knowledge, or people unfamiliar with these instructions to use the
product.
▪ Be aware of any hazards presented by the spray materials. Before using any pesticide or
other spray materials with the product, carefully read the label on the original container
and follow the instructions.
▪ Keep the area clear of all bystanders, children, and pets while spraying.
▪ Ensure that the spray wand is securely connected to the spray wand handle before using
the product. If necessary, use pliers to attach the spray wand to the spray wand handle.
▪ Remember to properly replace and tighten the spray tank cover after pouring liquid into
the spray tank.
▪ Use only consumer-grade water-based lawn and garden chemicals.
▪ Do not use commercial-grade chemicals or chemicals for commercial or industrial
purposes.
▪ Do not leave residue or spray material in the spray tank after using the product. Clean
after each use.
▪ Do not pour hot or boiling liquids into the spray tank. These can weaken or damage the
hose or spray tank.
▪ Do not overfill the tank.
▪ Always check for leaks. If any are found, correct them before using the product.
▪ Always inspect both the inside and outside of the product before each use.
▪ Liquids to be sprayed must be as thin as water. Thicker liquids will not spray properly.
▪ Spray materials may be premixed and poured into the spray tank using a funnel, if
necessary.
