POWXG6650 EN
Copyright © 2021 VARO P a g e | 6 www.varo.com
7.3 Mounting the additional handle (Fig. 5)
1 Unscrew the additional handle screw (15).
2 Insert the additional handle (15) into the holder underneath the handle (1).
3 The spare brush holder (19) must point towards the telescopic tube (7).
4 Screw the additional handle (15) tightly with the star-stud screw.
5 The additional handle is rotatable.
7.4 Unit assembly (Fig. 6)
1 Unfasten the screw socket (16).
2 Insert the telescopic tube (7) into the screw socket (16).
3 Turn the screw socket (16) until it is hand-tight.
If the telescopic tube (7) is not tight totally, the appliance will not start!
8 OPERATION
Caution: Risk of injury! Always check whether the device functions correctly
before using it.
When operating the joint brush, make sure to apply adequate pressure to
ensure optimal cleaning results.
Excessive pressure can cause damage to the device and in- creased bristle
wear.
8.1 Switching on and off
1 Loop the end of the extension cable and hang it onto the cable tension relief to ease the
tension on the cable.
2 Plug the tool into the mains.
3 To turn on, use your thumb to actuate the lock-off switch (3), then press the On/Off
switch (2). Re- lease the lock-off switch.
4 To turn off, release the On/Off switch (2).
The brush will keep rotating for a few seconds after the device has been
switched off. Keep the brush away from hands and feet.
Do not try to lock the on/off switch in place. Do not use the device if the switch
is damaged. A damaged switch may cause an injury risk due to the motor not
being switched off after releasing the on/off switch.
8.2 Length adjustment (Fig. 7)
The telescopic arm enables you to adjust the device to your individual height.
Unfasten the screw socket (6), adjust the telescopic arm (7) to the desired length and re-
fasten the screw socket.
