783524

Vibiemme Domobar Super Seite 36

36
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
32
16) Place a suitable container under the hot water wand. Open the hot water valve and turn the power switch to
Position I. Pump about 16 ounces of solution through the wand. Turn the Power Switch to Position 0 and then
close the hot water tap and unplug the machine.
17) At this point, the de-scaling agent has been pushed through all possible avenues where water can be passed.
Leave the machine off, unplug the power cord, and allow the machine to sit for a few hours. Refer to the instruc-
tions on the de-scaling agent’s container for a better idea of how long this should take. The amount of soaking
time is also a matter of the mineral content of your water, how much use your machine gets, and how long it
has been since the last de-scaling.
18) After the requisite time has passed, place a suitable vessel under the hot water tap, plug in the machine, open
the hot water valve, and turn the power switch to Position I. Pump about 8 ounces of solution through the wand.
Turn the Power Switch to position 0 and then close the hot water tap and unplug the machine. If the liquid you
drained looks quite fouled with scale, refill the reservoir with de-scaling agent by pumping another 16 ounces
of cleaner through the hot water wand (repeating the process starting back at step 15. Excessive scale in the
drained water indicates that you need to de-scale more often. If the water does not look very polluted with hard
water deposits that have been dissolved, continue with step 18.
18) Empty and thoroughly wash and rinse the water reservoir, fill it with the water you normally use in the ma-
chine, and replace the hose with the particle filter in the end back into the reservoir (if used, do not replace the
water softener yet).
19) Place the bypass hose in a suitable container. Removing this hose from the reservoir will keep the water in
the reservoir free from the de-scaler which is still in the pressure relief system.
20) Place a container under the grouphead, turn the power switch to Position I and immediately turn on the brew
cycle for fifteen seconds or more to flush out the grouphead and thermosyphon pipes. Turn off the brew cycle
and immediately turn the Power Switch to position 0.
21) Lock the Portafilter with the blind filter basket in place on the grouphead. Turn the Power Switch to Position
I and run the brew cycle for five or ten seconds after the brew pressure gauge reaches about 9 BAR to flush the
over pressure relief valve. Turn off the Brew Cycle and turn the Power Switch to Position 0.
22) Remove, rinse, and replace the blind portafilter.
Turn the Power Switch to Position I and t
urn the brew cycle
on and off a few times as when you are backflushing to clear the rest of the grouphead. Turn the brew cycle off
and turn the Power Switch to Position 0.
23) With the autofill wire still disconnected, place a suitable container under the steam wand and open the steam
valve. Turn the power switch to position “I” only. The autofill is defeated and so the machine will pump a stream
of water through the steam wand. Continue pumping until the water is clean and is free of descaling agent. Close
the valve and set the Power Switch to Position 0. Remember to check the reservoir level during this process.
24) Once again, place a suitable vessel under the hot water tap, open the hot water tap and turn the Power Switch
to Position I. Allow a stream of water to come from the steam wand until the water is clean and is free of des-
caling agent. Close the valve and set the Power Switch to Position 0.
25) Repeat steps 18 through 24 until the water you drain is tasteless (totally free from the taste of the cleaner).
This might take as many as three or more rinses.
CAUTION: Most proper de-scaling agents are a form of citric acid which is food grade, and in highly
diluted form is safe to consume. Sample only a very small amount (one drop on a clean fingertip) to be safe.
Thoroughly wash your hands in hot, soapy water before and after doing this test.
26) When the drain water is clean and free from the acidic taste of the cleaner, turn the power switch to “0” and
unplug the machine.
… 36 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Vibiemme Domobar Super wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info