484572

Vibiemme Vibiemme Double Domobar version 3 Seite 64

64
Zoom out
Zoom in
Vorherige Seite
1/74
Nächste Seite
58
2 If you equipped your machine with an in-reservoir water softener, remove it from the intake hose and place
it aside until this process is completed. The descaling agent can damage the water softener if it is left in place
during this process and can damage the espresso machine as well! Do not reinstall the water softener until
this entire procedure is completed.
3 The original particle filter which came with the machine that fits onto the end of the hose must be installed.
The original particle filter will stop any foreign matter from entering the machine.
5 Premix the descaling solution according to the manufacturer’s recommendations. You will need a total of
about 3 quarts (3 liters) of solution. If you are using a powdered descaler, heat one-half the amount of water
the instructions of the product call for, mix the powder in that water and allow to dissolve, then add cold
water to bring the total volume to the correct level.
CAUTION: The pump is not designed to pump hot water.
6 Carefully pour the de-scaling agent into the DD’s reservoir, filling it to about 1/2” (2cm) from the top.
CAUTION: Do not allow the descaling solution to drip or splash into the machine.
7 Turn the power switch to “Position I” and allow the machine to reach operating temperature.
8 Remove the drip tray cover and if necessary, empty the drip tray. Replace the drip tray.
9 Place a large, heat-resistant container under the group, such as a large measuring cup of heat-resistant glass
(we will refer to this as the “vessel” from this point on). Lift the brewing lever to the brew position and pump
16 ounces (0.5 liters) of solution through the machine and into the vessel. Discard the dispensed water. As
you move through these steps, do not allow the reservoir to become empty.
WARNING: In many of these steps, such as when pumping the de-scaler through the brewhead and
removing the hoses from the water reservoir, splashing acid can create a safety hazard. Gloves, eye
protection, and protection for the working surface are required.
4 FOR PLUMBED MACHINES ONLY - If you have been supplying the DD with water using
the plumbed option, access the lever on the bottom of the machine and turn it to face the hot water
wand’s side of the machine (pointing to the right when you are facing the front of the machine).
Remove the reservoir and remove the screw in the center of the reservoir’s platform. Place the
reservoir on the platform and push down on it and release it. It should click when pushed down and
click once again when released. Removing this screw prevents the machine from running with an
empty reservoir which can damage the pump or other components.
CAUTION: Running the machine without an ample water supply can damage the pump and
other parts. Damage from insufficient water is not covered by the warranty.
Priming the Pump.
A Rotary pumps were not originally designed to draw water in from a reservoir. Because of that, it
is a good idea to prime the pump at this time to be sure that it will correctly draw water from the
reservoir. It is not always necessary to do this, but it insures that the pump is protected from running
without water.
A Lift the hose out of the reservoir and remove the filter from the end of the hose.
B Hold the hose straight up and using a suitable tool (turkey baster, syringe, or small funnel for ex-
ample) completely fill the hose with water.
C While still holding the filled hose upwards in one hand, turn the power switch to “Position I” and
lift the brew lever all the way. Almost immediately, the water in the hose should be drawn into the
pump. As soon as the water level in the hose begins to recede, immediately lower the brew lever
fully and turn the power switch to “Position 0.”
D Replace the filter on the end of the hose and drop it into the reservoir
… 64 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Vibiemme Vibiemme Double Domobar version 3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Vibiemme Vibiemme Double Domobar version 3

Vibiemme Vibiemme Double Domobar version 3 Zusatzinformation - Englisch - 3 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info