667318
48
Zoom out
Zoom in
Vorherige Seite
1/234
Nächste Seite
0478 111 9925 B - EN
46
11.3 Engine
Maintenance interval:
See engine instruction manual
To achieve a long service life, it is always
particularly important to maintain a
sufficient level of oil and to change the oil
and air filter regularly, as well as to
observe the recommended oil change
intervals.
Information regarding engine oil and oil
capacity can also be found in the engine
instruction manual.
The cooling ribs must always be kept clean
to ensure that the engine is adequately
cooled.
11.4 Gearbox
MB 756.0 YS, MB 756.0 YC:
Maintenance interval:
Every 1000 operating hours/
at least once a year
The hydrostatic gearbox must only be
maintained by trained personnel. VIKING
recommends VIKING specialist dealers.
MB 756.0 GS:
The 3-speed gearbox is maintenance-free.
11.5 Blade brake clutch maintenance
Maintenance interval:
Once a year
The blade brake clutch is subject to natural
wear.
It may only be maintained by trained
personnel. VIKING recommends VIKING
specialist dealers.
11.6 Checking blade wear
Maintenance interval:
Before each use
Checking procedure
Place the machine in the cleaning
position. (Ö 11.1)
Clean mowing blade (1) and check for
notches and cracks.
Use slide calliper (2) to measure the
blade thickness A at several points.
Measure the blade width as illustrated
at the points B and C on the left and
right of the blade.
Wear limits:
The blade thickness A must be at least
2,5 mm at any point.
The blade width must be at least 80 mm at
point B and at least 55 mm at point C.
Different wear limits apply if e.g. the
mulching blade available as a special
accessory is installed in the lawn mower
instead of the supplied mowing blade.
11.7 Removing and installing the
mowing blade
Removing
Place the machine in the cleaning
position. (Ö 11.1)
Hold mowing blade (1) and loosen
blade fastening screw (2).
Remove blade fastening screw (2),
retaining washer (3) and mowing
blade (1).
Assembly
Clean the blade contact surface and
blade holder.
Secure the blade fastening screw with
Loctite 243.
Place mowing blade (1) on blade
holder (4) as illustrated.
Position retaining washer (3) as
illustrated and tighten with blade
fastening screw (2) to 60 - 65 Nm.
Risk of injury!
Blades are subjected to differing
degrees of wear depending on the
location and duration of use. If you
use the machine on sandy ground
or use it frequently under dry
conditions, the blade will be
subjected to greater loads and will
wear more quickly than the
average.
A worn blade may break off and
cause serious injuries. The
instructions for blade maintenance
must therefore always be
observed.
Risk of injury!
Observe the safety instructions in
the "For your safety" section.
(Ö 4.7)
20
Risk of injury!
Always wear gloves.
Avoid damage to the machine!
The mowing blade must be
replaced if notches or cracks are
detected or if a wear limit is
reached (Ö 11.6).
21
48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Viking MB 756 YS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info