667318
49
Zoom out
Zoom in
Vorherige Seite
1/234
Nächste Seite
47
DEFRNLITESPTPLHURU EN
0478 111 9925 B - EN
11.8 Sharpening the mowing blade
If mowing results deteriorate over time,
this is usually the result of a blunt mowing
blade.
The following points must be noted when
resharpening:
Remove the mowing blade. (Ö 11.7)
Cool the mowing blade when
sharpening, e.g. with water. The blade
must not be allowed to display blue
colouring, as this would reduce its
cutting quality.
Sharpen blades evenly to prevent
vibration due to imbalance.
The cutting angle of 30° must be
observed.
Observe the wear limits when
sharpening.
Remove any sharpening burr.
11.9 Maintaining cables
The cables are adjusted correctly at the
factory.
The throttle cable and the blade brake
clutch cable must only be maintained by
trained personnel. VIKING recommends
VIKING specialist dealers.
After prolonged use or under certain
conditions, it can be necessary to adjust
the self-propulsion cables.
Adjusting the hydro self-
propulsion cable
MB 756.0 YS, MB 756.0 YC
Maintenance interval:
As required
Adjustment of the cable can be necessary
if the maximum driving speed is no
longer achieved over time.
if self-propulsion is permanently
engaged. This means that the lawn
mower automatically begins to move
when the recoil starter rope is pulled,
despite the self-propulsion lever not
being actuated.
Adjusting the cable
1 Push driving speed lever (1)
fully forwards.
2 Loosen lock nut (2), loosen
shift linking (3) by turning adjustment
nuts (4).
3 Adjust cable (5) using the two
nuts (6, 7).
When correctly adjusted, the cable is
tensioned slightly and pin (8) is
positioned right at the bottom of
guide (9). The machine can be pulled
back – the wheels are not blocked
during this process.
4 Adjust the shift linkage without play
using adjustment nuts (4), then tighten
lock nut (2) again.
Adjusting the gearshift cable
MB 756.0 GS
Maintenance interval:
As required
Adjustment of the cable is necessary
if, following lengthy use, the individual
gears can no longer be engaged.
Adjusting the cable
Tension cable (1) using the two
nuts (2, 3) on the underside of the
handlebar so that all three gears can be
correctly engaged.
Adjusting the self-propulsion
cable
MB 756.0 GS
Maintenance interval:
As required
Adjustment of the cable is necessary
if, after a lengthy period of use, self-
propulsion does not engage when the
self-propulsion lever is actuated.
if self-propulsion is permanently
engaged. This means that the lawn
mower automatically begins to move
when the recoil starter rope is pulled,
despite the self-propulsion lever not
being actuated.
Checking the cable tension:
1. Engage 3rd gear and pull the recoil
starter rope – the lawn mower is not
driven.
2. Pull the self-propulsion lever to the
handlebar and hold, pull the recoil
starter rope - the lawn mower is driven.
Risk of injury!
The prescribed tightening torque
must be observed.
Retaining washer (3) must be
replaced each time the blade is
installed.
Blade fastening screw (2) must be
renewed each time the blade is
replaced.
22
23
Risk of injury!
The self-propulsion cable must be
correctly adjusted before the
machine is operated.
24
49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Viking MB 756 YS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info