Bedienungsanleitung Viking MT 4112SZ (Seite 48 von 332) (Englisch, Dänisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

667331

Zoom out

Zoom in

Vorherige Seite

1/332

Nächste Seite

0478 192 9803 B - EN

● Remove the mowing deck. (Ö 12.1)

● First, remove accumulated clipping

deposits in the mowing deck housing

using a stick.

● Clean the underside of the mowing

deck with water and a brush.

● Remove grass residues from the

mowing deck and engine compartment.

● Clean the mowing blades with water

and a brush.

13.18 Combustion engine

Observe the operating and maintenance

instructions contained in the attached

engine instruction manual.

To achieve a long service life, it is always

particularly important to maintain a

sufficient level of oil and to change the

engine oil and air filter regularly.

13.19 Gearbox

For the user, the gearbox is maintenance-

free.

During the inspections of the machine by

the specialist dealer, the required

maintenance operations are performed on

the gearbox.

13.20 Storage

Before putting the machine into storage,

the section "For your safety" and

especially the section "Storage for

prolonged periods of inoperation" must be

carefully read and observed. (Ö 4.)

The place of storage should be dry and

free of dust. The machine should also be

stored out of reach of children.

Any machine faults must be remedied prior

to storage in order to maintain a safe

operating condition.

Close the fuel cock prior to storage.

Remove the ignition key and keep in a

place where no unauthorised persons,

especially children, can access it.

13.21 Extended periods of inoperation

(e.g. winter break)

Note the following points when

immobilising the ride-on mower for

long periods:

– Carefully clean all external parts of the

engine and machine, in particular the

cooling ribs.

– Thoroughly lubricate/grease all moving

parts.

– Remove the fuel from the fuel tank and

carburettor (e.g. by running empty).

– Engage the parking brake. (Ö 8.11)

– Observe the information in the engine

instruction manual.

– Perform an engine oil change (engine

instruction manual). (Ö 13.10)

– Disconnect the battery. (Ö 13.15)

– Store the battery safely in fully-charged

condition, in a cool and dry room.

13.22 Following storage for extended

periods (e.g. over winter)

Note the following points after long

periods of inoperation:

– Check the battery voltage before

installing the battery.

– Insert the battery. (Ö 13.15)

– Connect the battery. (Ö 13.15)

– Check the tyre pressures. (Ö 13.23)

– Open the fuel cock if necessary.

(Ö 13.12)

– Check the fuel-tank level and fill if

necessary.

– Perform an engine oil change if

necessary. (Ö 13.10)

– Check the engine oil level and top up if

necessary. (Ö 13.9)

13.23 Tyre pressure

If the battery voltage is lower than

11.5 V, fully recharge the battery

using a battery charger before

installation.

Correct tyre pressure is an

important prerequisite for alignment

of the mowing deck and for a clean

cutting pattern.

Moreover, the turf may be damaged

by the tyre studs in the case of

excessively high tyre pressure.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Viking MT 4112SZ Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Viking MT 4112SZ

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info