Bedienungsanleitung Vonroc PH502AC - Marsili (Seite 9 von 64) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch)

764175

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

9WWW.VONROC.COM

base material.

6. Now put the mounting bracket (10) on the

sleeve anchors (11), and mount it using the

washer and nut. Turn the nut until ﬁnger tight.

Both as shown on ﬁgure F.

7. Use a size 10 wrench to set the anchor by turn-

ing the nut three to four full turns.

8. Mount the remaining 2 mounting brackets (10)

onto the outer holes of the heater (1), as shown

on ﬁgure G.

9. Take the heater with the assembled brackets

to the mounting brackets mounted on the wall

or ceiling. Now pair both brackets with the bolt

(14) and nut (13), as shown on ﬁgure H.

10. Figure I shows a correctly assembled mounting

bracket assembly.

11. Take into account the minimum distances as

shown on ﬁgure J and K.

12. The heater can be adjusted until the maximum

angle, as shown on ﬁgure K and L.

13. Plug the patio heater into a grounded power

outlet. Check beforehand if the voltage rating

matches the device.

14. Take into account to mount the power cable in

correct matter, as shown on ﬁgure M and N.

Use tyraps to ﬁxate the cable to the mounting

brackets if necessary.

Note: the heater can also be mounted on a tripod

or metal stand. Follow the instructions supplied

with the tripod or stand, to mount the heater

properly.

Assembling the remote control (Fig. B)

• Flip the remote control (8) to the backside and

remove the battery cover.

• Insert 2 AAA/ Alkaline type batteries into the

remote control (8) in accordance with the

instructions and polarity of the batteries..

• Change the batteries in the same way depicted

above.

4. OPERATION

Switching on/off (Fig. A, B)

The heater can be turned on and off using the

remote control (8) or the mode button (6). Before

use, the power switch (5) on the heater must ﬁrst

be turned on.

Using the remote control

If you do not have the remote control in your pos-

session, please contact Vonroc customer service.

• First turn the switch (5) on the heater to the ‘I’

On position.

• Press the button (9) on the remote control (8) to

turn the heater on.

• To turn the heater off, again press the button (9)

on the remote control (8).

• Press the switch (5) on the heater to the ‘O’ Off

position to power off

Note: Make sure to point the remote control (8) in

the direction of the remote control receiver (10). All

VONROC heaters and their remote controls use the

same frequency, so it is possible to control several

heaters with just one remote.

Using the mode button

• First turn the switch (5) on the heater to the ‘I’

On position.

• Press the mode button (1) to turn the heater on

in level 1 – 1000W power level.

• Press the mode button (1) again to turn the

heater on in level 2 – 2000W power level.

• To turn the heater off, again press the mode

button (1).

Adjusting the power level (Fig. A, B)

The heater power can be adjusted in two levels:

• Level 1 - 1000W (50% power)

• Level 2 - 2000W (100% power)

The desired level can be selected using the remote

control by pressing either the Power level 1 button

(8) or the Power level 2 button (9). The level can

also be selected by using the mode button (6), see

chapter ‘switching on/off’.

5. MAINTENANCE

Always make sure that the machine is not

connected to the mains electricity when you

carry out any maintenance of the mechanism.

CAUTION: Risk of Electric Shock. DO NOT

open or try to repair the heater yourself.

Clean the machine casings regularly with a soft

cloth, preferably after each use. Make sure that the

ventilation openings are free of dust and dirt. Re-

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vonroc PH502AC - Marsili Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info