Bedienungsanleitung Vonroc SP502AC (Seite 6 von 56) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch)

764165

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

WWW.VONROC.COM

DESCRIPTION

The numbers in the text refer to the diagrams on

page 2-3.

1. Carry handle

2. Lock (ﬂoat switch)

3. Float on/off switch

4. Base

5. Hose connector

6. Water outlet elbow connector

7. Water outlet

8. Vent hole

3. ASSEMBLY

The larger the hose and hose connector

diameter, the greater the ﬂow.

32mm (inner diameter) hose must be used

to achieve maximum ﬂow rate.

The lower the delivery height, the greater

the ﬂow.

Attaching the outlet hose (Fig. A, B)

1. Decide which hose diameter you are going to

use. See ﬁgure B.

2. Cut off the smaller steps of the hose connector

(5) that are not needed, using a suitable knife

or saw (not included).This removes unnecessary

ﬂow restrictions and ensures maximum pump

capacity and water ﬂow.

3. Screw the outlet elbow connector (6) into the

water outlet (7).

4. Screw the hose connector (5) on the outlet

elbow (6).

5. Fit the hose on to the hose connector (5) and

secure with a stainless steel hose clamp (not

included).

6. Attach a suitable rope (not included) to the

carry handle (1), to lower the pump into deep

water and to lift the pump back out of the wa-

ter. Never lower or lift the pump by its cable.

4. OPERATION

Never use this pump in a pond or swimming

pool while people are present in the water!

Never pull the pump by its power cord. The

pump must be carried by, and placed in the

water using the carry handle (1) or if the

water is deep, be lowered on a rope tied to

the carry handle (1).

Always have the pump switched off and the

plug removed from the power socket before

placing it in or removing it from the water.

Only switch the power back on with dry

hands.

Never run this pump dry - out of the water.

If the appliance overheats, the thermal

cut-out will switch it off. If this happens

wait 5 minutes before using the pump

again.

Automatic air bleed valve: The automatic air

bleed valve eliminates any air pockets in the

pump. During this process, air escapes

through the vent hole (8) and air bubbles

appear underwater. This is not a defect of

your pump, but serves to remove air from

the pump. It may take several seconds for

the air to escape when the pump is

immersed for the ﬁrst time.

Automatic operation

The cable length between the ﬂoat switch

(3) and the ﬂoat switch lock (2) must

always be at least 10 cm.

1. To adjust the cut-in and cut-out height, attach

the ﬂoat switch (3) cable to the ﬂoat switch lock

(2) at the required length.

2. Lower the pump into water. It would be advisa-

ble to stand the pump on a solid platform at the

bottom to keep it upright, if practical to do so.

Ensure there are no obstructions around the in-

let openings around the base of the pump. The

inlet openings must be clear of mud or sludge

at the bottom of a pool.

3. Connect the mains plug.

4. When the pump is lowered into the water and

the power is switched on, it will start to operate

as soon as the ﬂoating switch (3) reaches the

minimum activation height (approx. 50cm) in

the water.

5. The pump switches off as soon as the ﬂoat

switch (3) has reached the switch-off height

(approx. 5cm) due to the falling water level.

6. Ensure that the ﬂoat switch (3) is not obstruct-

ed in any way.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vonroc SP502AC Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info