Bedienungsanleitung Vonroc SP502AC (Seite 7 von 56) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch)

764165

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

WWW.VONROC.COM

7. After use, switch off the pump and remove the

mains plug from the mains.

8. Lift the pump back out of the water.

Manual operation

Where manual operation is preferred, the motor

can be activated by raising the ﬂoat switch (3) by

hand (ON) or lowering it by hand (OFF).

Finish operation

After use allow the pump to run using clean water

for 2 - 3 minutes in order to remove residues and

particles that may have accumulated in the pump

and outlet hose.

5. MAINTENANCE

Before cleaning and maintenance, always

switch off the machine and remove the

mains plug from the mains.

During maintenance or cleaning never rest

the appliance of the on the turbine

(impeller).

There are no user serviceable parts in this ap-

pliance. If the appliance appears to be blocked,

switch off the power at the mains, remove the plug

from the socket and check the appliance for block-

ages (see ‘Blockages’).

BLOCKAGES

If you suspect the pump has become blocked,

switch off the power at the mains socket remove

the plug and examine the turbine. The turbine can

be accessed by removing the securing screws in

the base and/or sub base. Alternately try reaching

the suspected blockage through the outlet (7) in

the side of the pump.

Always ﬂush through with clean water after

every use.

STORAGE AND FROST POTECTION

The submersible pump and accessories that are

not completely drained can be destroyed by frost.

Completely drain the submersible pump and acces-

sories and protect them against frost.

Keep this appliance in well-ventilated dry premises

with temperature not going below +5°C.

When not in use, keep this appliance stored in a

safe place out of reach of children.

TROUBLE SHOOTING GUIDE

Problem Cause Remedy

Pump does not

start

No mains supply

Floater restricted

Check mains supply

Bring ﬂoater to

higher position

Pump is active

but no water is

being delivered

Turbine clogged Disconnect pump

from the power

supply and clean or

unblock the turbine

(see 'BLOCKAGES')

Pump will not

switch off

Floater restricted Bring ﬂoater to a

lower position

Pump will not

start or stops

during use.

Pump switched

off after short

operating periods

Thermal overload

safety switch has

activated

Power has tripped

Turbine clogged

Water too hot

Disconnect from

the power supply,

leave for 2 minutes

and clear the turbi-

ne (if required - see

'Blockages')

Check fuses and

electrical connec-

tions

Disconnect pump

from the power

supply and clean or

unblock the turbine

(see 'BLOCKAGES')

Ensure that the wa-

ter temperature has

not exceeded the

maximum of 35 C

ENVIRONMENT

Faulty and/or discarded electrical or

electronic apparatus have to be collected at

the appropriate recycling locations.

Only for EC countries

Do not dispose of power tools into domestic waste.

According to the European Guideline 2012/19/

EU for Waste Electrical and Electronic Equipment

and its implementation into national right, power

tools that are no longer usable must be collected

separately and disposed of in an environmentally

friendly way.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vonroc SP502AC Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info