Bedienungsanleitung Wamsler W3-90 (Seite 42 von 116) (Deutsch, Englisch, Französisch, Italienisch)

813243

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

3.2 Lighting

The performance control is set depending on the type of fuel as a function of the chimney

draught and the desired heating level. With firewood and particularly with softwood, only a

limited heating period is possible. Lignite briquettes are much better suited to burning

overnight, if they are placed on top of a layer of glowing embers.

Heating / using for the first time

 Before using make sure any fixings for transport are removed from the deflection plate

over the fire chamber and remove any stickers on the glass window, making sure no

traces remain.

Open the fire door by lifting the catch. When the stove is hot use a protective glove to do

this. Set the primary and secondary air settings as shown in Table 2 “Combustion air flow

settings”. Open the start damper. Place a starter briquette or some wood shavings on the

grid. Then add some smaller, then larger pieces of wood, light it and shut the fire chamber

door. Once the fire is burning strongly and there is a sufficient base of embers, add more

fuel and shut the start damper off.

The first time the stove is lit it should be done “gently”, with a small amount of fuel, to allow

the stove parts to get used to the heat. The first time the stove is heated there may be

some smoke and an unpleasant smell. Make sure that the room is well ventilated (open

windows and doors) and heat for at least an hour at the maximum nominal heat load. If the

maximum temperature is not reached the first time the stove is heated, then there may be

further unpleasant smells at a later date. Never throw pieces of fuel into the fire chamber,

but place them, as otherwise the lining may be damaged.

The loading door (fire door) must always be kept shut when the stove is in use.

It may only be opened when lighting, filling up or cleaning the fire chamber.

PLEASE NOTE:

If not working correctly, or if the chimney is not drawing properly, smoke may ap-

pear when the fire door is opened. It is very important to only open the fire door

slowly, initially just a crack, then wait a few seconds before opening fully. In addi-

tion, before opening the fire door to top up the fuel, make sure that only glowing

material is present: there must not be any visible flames.

3.3 Cooking and heating

Whenever the stove is being used for cooking or heating the start damper must be kept

shut.

For optimum cooking on the hob plate you are recommended to use pans with a flat base.

The hottest area is in the centre of the plate, so this is the best area to use to heat up a

pan quickly. The edges of the plate can be used to keep food warm. To get a faster heating

up time (to boiling point) we recommend using thinly chopped softwood.

The hob plate must not be overheated as this will damage the stove but not help in any

way with cooking.

3.4 Roasting and baking in the oven

The stove is equipped with an oven made of stainless steel with telescopic pull-out

shelves. The oven has a glass door in which there is a thermometer. The temperature

displayed should only be used as an indication when baking and roasting. In addition the

oven is supplied as standard with a roasting grid and a baking tray.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wamsler W3-90 Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info