Bedienungsanleitung Wanders Peppel (Seite 20 von 48) (Deutsch, Englisch, Holländisch, Französisch)

694508

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

6. Shield o all combustible materials within a radius of 100 cm from the stove openings with non-combustible materials.

7. Never cover the chimney breast with combustible material (e.g. paper covering).

8. The wall behind the stove must consist of, or be insulated with, re-proof materials. The insulation material must resist a

temperature of 700 °C and have a density of 80 kg/m3. Please see for insulation materials table below).

Installation

The Peppel is tested in accordance with the international EN 13240 standardization, and has an extra additional standardization

for optimally environment-friendly heating devices related to ue gases. The stove can be connected to a ue tube to which

several stoves are connected. The ue tube has a diameter of 150 mm.

The heating device must be placed by an acknowledged installer and according to the installation instructions

given below. The national and local rules and regulations for placing and using wood-burning stoves are equally

applicable. WANDERS does not give any guarantee if the Peppel is connected or installed incompletely or

incorrectly.

Supply of combustion air

The stove must have enough supply of fresh combustion air. If necessary, make an extra air supply opening as close to the

stove as possible to avoid draught. An extra opening for air supply is always required if:

• the space has a heat recovery system.

• the space has a central exhaust system.

• there is a cooker hood in the same space.

The air supply opening must be closable if it goes through a re-resistant wall. When there are several combustion devices in

the same space there must be enough air openings to guarantee proper combustion.

External air connection

The fresh air supply channel has a diameter of 100 millimetres. The air supply channel can be tted via a bottom or rear

connection. If the external air supply goes through a rewall, that channel must be able to be shut o. If the channel is longer

than 1 meter, including a bend of 90 degrees, the channel’s diameter will need to be increased.

To adjust the position of the external air supply, switch the connection piece (A) with the cover plate (B) by unscrewing the

bolts on the respective components.

Table for insulation material. Please note: only use the products that are mentioned in the marked area.

Insulation Packed Thermal conduction Max. appl. temp. Density

Nr. Art. Nr. Form Nr. Packed Nr. °C Nr. kg/m

10 mineral wool 01 bands 01 stitched mats 10 100 02 20

11 glass wool 02 loose wool stitched mats 12 120 03 30

12 rock wool 03 wool 02 stitched mats 14 140 04 40

13 waste products granule g. curve 2 16 160 05 50

04 felt 06 60

05 lamella mats 10

07 70

g. curve 1 08 80

06 stitched mats 11

09 90

07 plates g. curve 2 10 100

08 scales 72 720 11 110

09 segments 20 plates 74 740 12 120

10 interwoven g. curve 1 76 760 13 130

21 plates

g. curve 2 18 180

99 others 99 single 99 99

Select the insulation material from this table. Group 99 is NOT ALLOWED

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wanders Peppel Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info