Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: info@aktobis.de
1.7 If you wish to use the control via app, you must first download the "Tuya Smart" app on your smartphone
(tablet) from the app store. After downloading, open the app and make sure that your smartphone is connected
to your Wi-Fi network and that the Bluetooth function of your smartphone is switched on. Now follow the
instructions in the app to register. After registering, click on "Add device" in the app. Select the button
"Dehumidifier" under the category "Small household appliance". The
dehumidifier should now be displayed. Click on it to connect it to your smartphone via the app. As soon as your
smartphone is paired with the dehumidifier, the signal light of the WLAN function in the display stops flashing
and lights up continuously.
Now you can conveniently set the dehumidifier via app and at the same time read values such as the current
room humidity without having to stand directly in front of the device.
Note: If you do not use the WLAN function for a longer period of time or do not pair the dehumidifier with a WLAN
network, this function switches to standby mode and the signal light stops flashing. To reactivate the WLAN
function, switch off the unit and then press and hold the On/Off button for 5 seconds until you hear a tone
confirming the activation. The unit should now be switched on and the signal light should also flash again. The
WLAN function is active again.
2. Emptying the collection tank / When the "Condensation tank full" signal LED lights up
When the condensation tank is full, the signal light (tank full) lights up and the building dryer then
automatically stops its dehumidification operation. Carefully remove the condensation tank with
both hands and empty it. After you have pushed the condensation tank neatly back into the unit,
the dehumidification operation of the construction dryer will restart automatically within approx. 3
minutes.
3. Connecting a hose (optional)
3.1. The connection point for the drain hose is located at the rear of the building dryer (on the right-hand side).
3.2. Loosen the screw cap from the hose outlet.
3.3. Remove the sealing rubber (condensation tank rubber) from the screw cap.
3.4. Pass the matching hose through the screw cap.
3.5. Now screw the screw cap tightly back onto the hose outlet. Make sure that everything is properly seated and
that no water can leak out at the connections (see diagrams at the beginning of the next page).
