Bedienungsanleitung Webasto Dual Top ST 8 (Seite 15 von 19) (Englisch)

802472

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

Filling the boiler | 5

9026381C Dual Top ST 6 _ 8 - OI 15 / 19

NOTE

Draining the boiler as well as the frost protection mode

protect the heater and boiler against frost. Not all wa-

ter lines in the vehicle can be protected against freezing

due to installation variations.

When storing the vehicle, either choose a place that is

well protected against low temperatures or drain the

whole water system, including all lines and tubes (e.g.

with air pressure, see note in chapter4.7.1, "Draining

the boiler manually" on page 14 ).

Warranty claims for damage caused by frost will not

be honoured!

4.7.4 Frost protection

The frost protection mode is a safety feature for the heater only.

It does not prevent the water circuits inside and outside the

vehicle from freezing.

Store the vehicle at a place that is well protected against frost

or drain water contents if there is a risk of frost!

For Dual Top ST with a manual control panel: To avoid freezing

of the tubes and the boiler move mode selector knob (A) to

frost protection mode (5).

The indicator (C) on the control panel lights green when the

equipment is switched on. The red indicator on the mode se-

lector knob (A) illuminates.

The heater functions as in the wintermode, heating with hot

water production, but with lower values for air and water tem-

peratures.

For Dual Top ST with a programmable control panel: Make sure

the device is switched on.

1. Press MENU.

2. Press and to select “Frost Protection”.

3. Press OK. For Dual Top ST 6: The display shows: “Selection

completed“.

4. For Dual Top ST 8: Press and to select the desired

heat source:

Dual Top ST 8

“Diesel powered”

“1,000 W ~ 230 V” *

“2,000 W ~ 230 V” *

* Options “...W ~ 230 V” shown only when external 230 V

power supply is connected.

5. Press OK. The display shows: “Selection completed”.

NOTE

When the heater is already “ON”, the text “Selection

completed, press OK to change operation mode” is

displayed.

uPress OK.

After 3 seconds the power indicator (6) lights up in green and

the display changes to:

11000W

230V und … W: Only Dual Top ST 8

– “Heater ON”

– “ Frost Protection Boiler“

– “ diesel“, “ 1000 W“ or “ 2000 W” (depending

on heater type and selected heat source).

The heater functions as in the winter mode, heating with hot

water production, but with lower values for air and water tem-

peratures.

NOTE

When the frost protection mode is selected in depend-

ence on the selected heat source, diesel and electrical

power are used. Therefore, it should be ensured that

the battery is charged and there is enough diesel in the

tank when "Diesel mode" is selected. Check this fre-

quently.

NOTE

When ambient temperatures below -20 °C are expec-

ted, select heat source “Diesel powered” for 100%

frost protection of the system.

NOTE

Make sure that the boiler is filled with water when

choosing frost protection mode.

NOTE

The frost protection mode enables the user to park the

vehicle for a short time without being observed and

without having to worry about frost and frost damage.

During winter storage or when parking the unused

vehicle for a longer time, the entire water system

should be drained and the heater disconnected from

the battery to avoid unnecessary battery discharging or

possible frost damage.

5 Filling the boiler

Fill the vehicle fresh drinking water tank with your own hose,

which is kept and stored clean.

Before filling the tank rinse the hose thoroughly (approx. 30

seconds).

CAUTION

Always fill the tank with fresh drinking water only and

prevent dirt from getting into the entire water supply

system.

1. Fill the boiler with fresh drinking water at an ambient tem-

perature of at least 6 °C, or select:

- summer mode 40°C or 70°C, see chapter4.2.1, "Summer

mode (hot water only)" on page 7 or chapter4.3.6, "Sum-

mer mode (hot water only)" on page 9",

- winter mode (heating with hot water production), see

chapter4.3.8, "Winter mode (heating with hot water pro-

duction)" on page 10" or chapter4.2.3, "Winter mode

(heating with hot water production)" on page 7, to make

sure the electrical safety/drainage valve does not open!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Dual Top ST 8 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Webasto Dual Top ST 8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info