Bedienungsanleitung Weber Genesis E 330 (Seite 12 von 76) (Englisch, Französisch)

484257

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

GAS INSTRUcTIoNS

TYPE OF GAS

Your natural gas grill is factory built to operate using natural gas only. Never attempt to

operate your grill on gases other than the type specified on the grill rating plates.

Yourgrilloperatesat7"ofwatercolumnpressure.Ifreplacementofthehosebecomes

necessary, factory specified parts are required. See your local dealer.

For safety and design reasons, the conversion of a Weber

grill from operation using

Natural gas to operation using LP gas is not allowed.

◆

WHAT IS NATURAL GAS?

Natural gas, often called methane, is a safe modern fuel. Natural gas is supplied by your

local utility and should be readily available if your house is already heated with gas.

◆

NATURAL GAS CONNECTION

Uncoil the NG supply hose and route the end out the access hole at the back panel of

the cabinet (1).The330unitrequiresa1/2"hoseasopposedtothe3/8"hoseforthe

310 & 320. Weber

recommendsmovingthegrillatleast24"fromthegassupplyand

any combustible surfaces. After the gas supply has been run and checked for leaks in

accordance to the assembly instructions, you are ready to grill. To connect the hose

to the gas supply, pull back the outer fitting, insert the hose fitting all of the way, and

release the outer fitting. This process will produce a gas joint.

◆

LEAK CHECK PREPARATION

Check that all Burner Valves are Off

Valves are shipped in the OFF position, but you should check to be sure that they are

turned off. Check by pushing in and turning clockwise. If they do not turn, they are off. If

they do turn continue turning them clockwise until they stop, then they are off.

Check the Flexible Hose to Manifold Connection

The natural gas hose was attached during the manuafacturing process. We do

recommend that the hose to gas manifold connnection be leak tested, following

guidelines in this Owner’s Guide, prior to barbecue operation.

To perform leak checks: Slide back the collar of the quick disconnect (2). Push male

fitting of the hose into the quick disconnect, and maintain pressure. Slide the collar

closed (3). If it does not engage or lock, repeat procedure. Gas will not flow unless the

quick disconnect is properly engaged.

◆

1 Swivel connection

2 Install covers when hose is disconnected

3 Shut-off valve

4 Coat this pipe nipple with gas-resistant pipe dope

5 Socket

6 Male connection

1 Socket

2 Sleeve

3 Push sleeve back

4 Plug

Push plug until sleeve snaps forward, locking plug in socket.

(This turns on gas automatically.)

When properly assembled, the plug cannot be removed without pushing the sleeve back.

To disconnect, push sleeve back and pull out plug.

(This automatically shuts off gas.)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Weber Genesis E 330 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Weber Genesis E 330

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info