Bedienungsanleitung Weber Genesis II - E-610 (Seite 42 von 88) (Englisch, Französisch, Spanisch)

656581

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

Getting Started

UNLOCK GRILLING HAPPINESS

m DANGER: Do not use a ﬂame to check for gas

leaks. Besure there are no sparks or open

ﬂames in the area while you check for leaks.

m DANGER: Leaking gas may cause a ﬁre or

explosion.

m DANGER: Do not operate the grill if there is a

gas leak present.

m DANGER: If you see, smell, or hear the hiss of

gas escaping from the liquid propane tank:

1. Move away from liquid propane tank.

2. Do not attempt to correct the problem

yourself.

3. Call your ﬁre department.

m DANGER: Always close the tank valve before

disconnecting the regulator. Do not attempt

to disconnect the gas regulator and hose

assembly or any gas ﬁtting while this grill is in

operation.

m DANGER: Do not store a spare LP tank under

or near this grill. Never ﬁll the cylinder beyond

80% full. Failure to follow these statements

exactly may result in a ﬁre causing death or

serious injury.

LP Tank Installation &

LeakChecking

Installation Location

The tank is hung onto the tank scale which is located

outside the cabinet base under the right side table.

The shape of the collar assembly (the metal protective

ring around the tank valve) determines one of two

directions in which the tank will correctly hang on the

tank scale (A).

Inspect the Tank

1) Conﬁrm that the tank valve is fully closed. Close by

turning valve clockwise.

2) Conﬁrm that the tank valve is the proper mating

type for the regulator (B).

3) Inspect the tank valve, including the internal rubber

seal for damage or debris (C). If damaged, return

tank to local retailer.

Install The Tank

1) Check that all burner control knobs are in the

o position. Check by pushing in and turning

knobs clockwise.

2) Loosen hand nut and rotate tank lock up(D).

3) Lift tank into position on the tank scale (E).

4) Rotate the tank lock down. Tighten the hand nut.

5) Screw the regulator coupling onto the tank valve,

turning clockwise (F). Hand-tighten only. Using a

wrench could damage the regulator coupling and

could cause a leak. Proceed to “CHECKING FOR

GASLEAKS.”

What is a Leak Check?

Once the LP tank is properly installed, it is necessary

to perform a leak check. A leak check is a reliable way

to verify that gas is not escaping after you connect the

tank. The ﬁtting where the regulator connects to the

tank should be tested each time a tank is reﬁlled and

reinstalled.

Checking for Gas Leaks

1) Wet ﬁttings (G) with a soap and water solution,

using a spray bottle, brush, or rag. You can make

your own soap and water solution by mixing 20%

liquid soap with 80% water; or, you can purchase

leak check solution in the plumbing section of any

hardware store.

2) Slowly open gas supply by turning tank valve

counterclockwise while checking for bubbles.

3) If bubbles appear there is a leak:

a) If the leak is at the cylinder (H), turn o the gas.

DONOT OPERATE THE GRILL. Disconnect the

tank and return the tank to your local retailer.

b) If the leak is at the regulator (I), turn o the

gas. DONOT OPERATE THE GRILL. Contact the

Customer Service Representative in your area

using the contact information on our website.

4) If bubbles do not appear, leak checking is complete:

a) Turn gas supply o at the tank and rinse

connections with water.

NOTE: Since some leak test solutions, including soap and

water, may be slightly corrosive, all connections should

be rinsed with water after checking for leaks.

Additional Leak Check Precautions

The fuel system in your grill features other

connections and ﬁttings. These factory-made

connections have been thoroughly checked for gas

leaks and the burners have been ﬂame-tested.

However, it is recommended that a thorough leak

check be performed annually. Instructions for this can

be found online at weber.com.

68021_Gen_II_LP_080116_US.indd 10 8/15/16 10:05 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Weber Genesis II - E-610 Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Weber Genesis II - E-610

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info