Bedienungsanleitung Westfire WF26 (Seite 8 von 28) (Deutsch, Englisch, Holländisch, Dänisch, Französisch)

813313

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

WESTFIRE · WF26 WF27 WF28

STOVE PERFORMANCE & TESTING

Westﬁre UNIQ 26, 27 & 28 have been approved in accordance with EN 13240.

PREPARATORY WORK AND SAFETY CHECKS

IMPORTANT WARNING

This stove must not be installed into a chimney that serves any other heating appliance. There must not be an

extractor fan ﬁtted in the same room as the stove as this can cause the stove to emit fumes into the room.

CHIMNEY

Chimney Connection

Flue Diameter 125 mm

IMPORTANT: Once the stove is unpacked and checked it is necessary to remove the central bar from the ﬂue collar

of the stove before installation. To remove unbolt collar remove bar and replace collar.

In order for the stove to perform satisfactorily the chimney height must be sufﬁcient to ensure an adequate

draught so as to clear the products of combustion and prevent smoke problems into the room.

Minimum draft: Westﬁre UNIQ 26, 27, 28 stove has been tested with a draft of 12 Pa. Maximum draft 25 Pa.

Flue gas ﬂow 4.4 g/sec.

Flue gas temperature 263°C. approximately 12 Pa.

NOTE: The outlet from the chimney should be above the roof of the building in accordance with the provisions of

Building Regulations Approved Document J. If installation is into an existing chimney, then it must be sound and

have no cracks or other faults which might allow fumes into the house. Older properties, especially, may have

chimney faults or the cross section may be too large. Westﬁre Aps recommend the use of a solid fuel ﬂue lining

system for all installation into existing chimneys. All chimney systems must be used in accordance with Building

Regulations Approved Document J.

If there is no existing chimney then either a prefabricated block chimney in accordance with Building Regula-

tions Approved Document J or a twin walled insulated stainless steel ﬂue to BS 1856-1. These chimneys must be

ﬁtted in accordance with the manufacturer’s instructions and Building Regulations. A single wall metal ﬂue pipe is

suitable for connecting the stove to the chimney but is not suitable for using for the complete chimney. The con-

necting ﬂue pipe must have a minimum diameter of 125 mm and its dimension should be not less than the size

of the outlet socket of the stove. Registered smoke exempt models burning wood only can be installed on ﬂue of

125mm throughout. Any bend in the chimney or connecting ﬂue pipe should not exceed 45°. 90-degree bends

should not be used other than within 150 mm of stove rear ﬂue outlet.

A chimney height of not less than 4.5 metres measured vertically from the outlet of the stove to the top of the

chimney should be satisfactory. Alternatively, the calculation procedure given in BS5854:1980 may be used as the

basis for deciding whether a particular chimney design will provide sufﬁcient draught.

If it is found that there is excessive draught in the chimney, then either an adjustable ﬂue damper or alternately a

draught stabiliser should be ﬁtted. The adjustable ﬂue damper should not close off the ﬂue entirely but should in

its closed position leave a minimum continuous opening free area of at least 20 % of the total cross-sectional area

of the ﬂue or ﬂue pipe. Adequate provision e.g. easily accessible soot door or doors must be provided for swee-

ping the chimney and connecting ﬂue pipe.

Stove model Weight Nominal heat output

Wood Smokeless fuels

UNIQ 26 105 kg 5.0 KW N/A

UNIQ 27 110 kg 5.0 KW N/A

UNIQ 28 120 kg 5.0 KW N/A

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Westfire WF26 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info