Bedienungsanleitung Westfire WF26 (Seite 10 von 28) (Deutsch, Englisch, Holländisch, Dänisch, Französisch)

813313

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

WESTFIRE · WF26 WF27 WF28

UNIQ 26,27,& 28

Top ﬂue exit 125 mm internal/150 mm external

Distance from rear to centre of ﬂue

UNIQ 26: 156 mm

UNIQ 27 & 28: 192 mm

Rear ﬂue exit 125 mm internal/150 mm external

Height to centre of rear ﬂue

UNIQ 26, 27 & 28: 895 mm

Closed combustion air intake 100 mm

Height to centre of air intake

UNIQ 26, 27 & 28: 110 mm

Westﬁre Insulated chambers

The Westﬁre UNIQ 26, 27, 28 wood burning stove is lined with heat deﬂection panels and bafﬂes, these panels

are designed to ensure the maximum efﬁciency and are an integral part of the clean burn process of the stove.

These bafﬂes should not be removed apart from for cleaning the stove. Any defective panels should be replaced.

Connection to chimney

Westﬁre UNIQ 26, 27, 28 wood stove has both rear and top ﬂue connector that allows connection to either a

masonry chimney or a prefabricated factory made insulated metal chimney in accordance with the instructions for

“Connection to chimney” given in the instruction booklet.

Commissioning and handover

Ensure loose parts are ﬁtted in accordance with the instructions, page 13. ‘Vermiculite ﬁre brick installation se-

quence’ before handover. Operation of primary and secondary air controls must be fully explained.

On completion of the installation allow a suitable period of time for any ﬁre cement and mortar to dry out, when

a small ﬁre may be lit and checked to ensure the smoke and fumes are taken from the stove up the chimney and

emitted safely to atmosphere. Do not run at full output for at least 24 hours.

On completion of the installation and commissioning ensure that the operating instructions for the stove are left

with the customer. Ensure to advise the customer on the correct use of the appliance with the fuels likely to be

used on the stove and warn them to use only the recommended fuels for the stove.

Advise the user what to do should smoke or fumes be emitted from the stove. The customer should be warned to

use a ﬁreguard to BS 6539 in the presence of children, aged and/or inﬁrm persons.

Operating your stove – UNIQ 26,27, 28

Initial lighting

The heat-resistant paint on your stove will cure and harden the ﬁrst time you light your appliance. The curing process

produces a good deal of smoke and odour, it is therefore important that the ﬁrst time you light your stove the room

should be well ventilated. During the process it is important to open and close the stove door periodically (every

30mins) during the ﬁrst couple of ﬁrings therefore preventing the door seal cord around the door from sticking and

coming away from the door. Once the Heat-resistant paint has hardened; the stove door must be kept closed except

when lighting the stove, adding ﬁrewood or removing ash in order to prevent ﬂue gas from escaping.

Lighting your appliance

Quality Firelighters should be used when lighting the stove. (Never use mentholated spirit, petrol or other

ﬂammable liquids). Lighting your stove with ﬁre lighters will be more reliable and easier than paper.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Westfire WF26 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info