GB12
MATERIAL SUPPLIED
Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, lamps and grease lters installed.
• Instructions for assembly and use
• multi-connection ange ø150/125-120
• 4 screw caps
• exhaust pipe connector ø150
• 4 screws 4x12
• 4 screws 4 x16
• 2 screws 3.5x9.5
The hood is designed for installation and use in “Extractor version” or in “Filter version”.
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector
Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector
IMPORTANT: If already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recycled into the surrounding environment.
IMPORTANT: Check that air recirculation is ensured.
If the hood does not have the carbon filter/s, order one/them and fit before use.
Install the hood away from very dirty areas, windows, doors and heat sources.
The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, a qualified technician must ensure that the materials
are suitable according to the type of wall/ceiling.
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
Adjacent wall units Adjacent wall units
centre line
65 cm (gas or combi cookers)
50 cm (electric cookers)
hob surface
Wall unit interior 600 mm min.
Wall unit interior 900 mm min.
INSTALLATION DIMENSIONS
This type of hood must be installed inside a wall unit or similar support.
