528407
6
Zoom out
Zoom in
Vorherige Seite
1/13
Nächste Seite
We recommend that you check and clean the filter
regularly, at least two or three times a year, especially:
If the “Clean pump” indication lights up:
If the appliance is not draining properly or if it fails to
perform spin cycles.
If the washing machine stands in a room prone to frost, you
have to drain residual water after each wash to avoid damages.
IMPORTANT: make sure the water has cooled
before draining the appliance.
1. Stop the appliance and unplug it.
2. To open the plinth (depending on the model):
- Push down the tabs right and left (if available) to
release the plinth and remove it (picture “A”).
- Remove the plinth by using the siphon of the detergent
dispenser: push downwards one side of the plinth with
your hand, then push the siphon’s nose into the gap
between plinth and front panel and pry open the plinth
(picture “B”).
3. Place a container near the washing machine.
4. If your washing machine has an emergency drain hose:
- Unclip the emergency drain hose, or pull out the
emergency drain hose from the washing machine’s
base (depending on the model).
- If there is no emergency drain hose: place a broad,
flat container beneath the filter (picture “D”). Ignore
steps 5 - 8 and proceed with 9.
5. Hold the emergency hose’s end into the container and
remove the stopper (picture “C”).
6. Wait until all the water has drained, then refix the stopper
at the hose’s end (picture “E”).
7. Refix the emergency drain hose to the clip, or push it
back into the washing machine’s base (depending on
the model).
8. Lay an absorbable cotton cloth (e.g. a towel) on the
floor in front of the filter.
9. Slowly open the filter by turning it counter-clockwise
(picture “F”); wait until all the water has drained, then
unscrew the filter completely and remove it.
10. Tilt the appliance forwards carefully (a second person
must help you) to allow the water to flow out completely.
11. Clean the filter and the filter chamber; check that the
pump rotor in the filter chamber moves freely.
12. Re-insert the filter and screw it in clockwise as far as
it will go.
13. Pour about 1 litre of water into the detergent dispenser
to reactivate the “Eco system”. Check that the filter is
inserted properly and securely and no water comes out.
14. Reinstall the plinth (picture “G”); if necessary, tilt the
washing machine slightly backwards for doing that (a
second person must help you).
15. Plug in the washing machine. It is now ready for
operation again.
GB 6
DRAINING RESIDUAL WATER/
CLEANING THE FILTER
B
C
A
D
E
F
G
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Whirlpool Seattle 1400 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Whirlpool Seattle 1400

Whirlpool Seattle 1400 Bedienungsanleitung - Deutsch - 12 seiten

Whirlpool Seattle 1400 Kurzanleitung - Deutsch - 2 seiten

Whirlpool Seattle 1400 Bedienungsanleitung - Englisch - 2 seiten

Whirlpool Seattle 1400 Bedienungsanleitung - Holländisch - 12 seiten

Whirlpool Seattle 1400 Kurzanleitung - Holländisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info