Bedienungsanleitung Whirlpool WQ9IMO1L (Seite 23 von 40) (Englisch)

756839

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Registering your refrigerator in your account is a necessary step

in order for you to take full advantage of the Smart features. When

prompted by the app, enter the SAID (case sensitive), which can

be found on a sticker on the front side of the right hand hinge

cover of the refrigerator.

My Smart Appliance ID# is:

nThe Wi-Fi status indicator on the refrigerator control panel

will blink slowly while your refrigerator and router attempt to

connect.

nNote that this blinking only applies to rst-time registration

after provisioning. No blinking behavior for automatic

reconnection after a connection is established.

nOnce you’ve connected your refrigerator to your home

Wi-Fi network, it will remain linked even if the power goes out,

you move the appliance, or if you put it in storage for

a while.

nIf you replace your wireless router (or get a different

Smart refrigerator), you will need to repeat this connectivity

set-up process.

Water and Ice Dispensers

IMPORTANT:

nAllow 3 hours for the refrigerator to cool down and chill water.

nAllow 24 hours to produce the rst batch of ice. Discard the

rst 3 batches of ice produced.

nThe dispensing system will not operate if the left-hand

refrigerator door is open.

Flush the Water System

Air in the water dispensing system can cause the water dispenser

to drip. After connecting the refrigerator to a water source or

replacing the water lter, ush the water system.

Flushing the water dispensing system forces air from the water

line and lter and prepares the water lter for use. Additional

ushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of

the dispenser.

1. Using a sturdy container, depress and hold the water

dispenser paddle for 5 seconds.

2. Release the dispenser paddle for 5 seconds. Repeat steps

1 and 2 until water begins to ow.

3. Once water begins to ow, continue depressing and releasing

the dispenser pad (5 seconds on, 5 seconds off) until a total

of 3 gal. (12 L) has been dispensed.

Calibrate Measured Fill

Household water pressure may affect the accuracy of the

Measured Fill feature. So, for optimum performance of your

water dispenser, you must rst calibrate Measured Fill.

IMPORTANT:

nFlush the water system before calibrating Measured Fill.

nFor best results, calibration should be performed when water

is not being used in the house.

The Smart Appliance

Identication Number

(SAID) is located on

a sticker on the front

side of the right-hand

hinge cover of the

refrigerator.

A. Water dispenser paddle

B. Ice dispenser paddle

Note: During product registration, mobile phone and appliance

have to be connected to the same Wi-Fi network

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WQ9IMO1L Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WQ9IMO1L

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info