Bedienungsanleitung Whirlpool WQ9IMO1L (Seite 24 von 40) (Englisch)

756839

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

1. Place a sturdy measuring cup (1-cup [0.2 L] size) on the

dispenser tray centered in front of the ice/water dispenser

paddle.

NOTE: Depending on your model, a measuring cup may be

provided.

Ensure that you do not have any Measured Fill preset selected.

2. Touch and hold the Measured Fill button for 3 seconds

to enter into Calibration mode. The Calibration icon and

Measured Fill icon will illuminate and remain lit while the

Measured Fill feature is being calibrated.

NOTE: You may touch MEASURED FILL to exit at any time in

Calibration mode. The Calibration and Measured Fill icons will

disappear.

3. Press and hold the water dispenser paddle, as needed, to

dispense water to the 1-cup ll line in the measuring cup.

NOTE: If overlling or spilling occurs, discard the water and

restart the calibration process.

4. When 1 cup of water has been correctly dispensed into

the measuring cup, touch MEASURED FILL to conrm the

calibration.

5. When Measured Fill calibration has been conrmed, the

Calibration icon will disappear and the display will return

to the home screen.

Dispensing

Touch CUBED ICE or CRUSHED ICE for your ice selection.

NOTES:

nFor crushed ice, cubes are crushed before being dispensed.

This may cause a slight delay when dispensing crushed ice.

Noise from the ice crusher is normal and pieces of ice may

vary in size.

nWhen changing from crushed to cubed, a few ounces of

crushed ice will be dispensed along with the rst cubes.

Dispensing Water

IMPORTANT:

nDispense at least 1 qt (1 L) of water every week to maintain

a fresh supply.

nIf the ow of water from the dispenser decreases, it could

be caused by low water pressure.

n With the water filter removed, dispense 1 cup (0.2 L)

of water. If 1 cup (0.2 L) of water is dispensed in

8 seconds or less, the water pressure to the refrigerator

meets the minimum requirement.

nIf it takes longer than 8 seconds to dispense 1 cup

(0.2 L) of water, the water pressure to the refrigerator is

lower than recommended. See the “Water Supply

Requirements” and “Troubleshooting” sections for

suggestions.

To Dispense Water - Standard:

1. Press a sturdy glass against the water dispenser paddle.

2. Remove the glass to stop dispensing.

NOTE: The Dispense Water button does not enable standard

dispensing. It only functions in Measured Fill mode.

To Dispense Water - Measured Fill:

Measured Fill allows you to dispense a specied amount

of water with the touch of a few buttons.

1. Put a sturdy glass under water spout. Touch

MEASURED FILL to activate.

NOTE: The amount of water you select will be dispensed.

Make sure the container can hold the entire volume. If ice

is in the container, you may need to adjust your selection.

2. Touch MEASURED FILL to turn on, then touch to select

8 oz (0.2 L), 16 oz (0.5 L), or 32 oz (1 L). Touch the fourth time

to exit Measured Fill display.

3. Touch DISPENSE WATER (center button) or press paddle and

the selected amount of water will be dispensed.

NOTES:

nThe Measured Fill dispenser will automatically time out after

1 minute of inactivity.

nYou can rell several glasses with the same measurement by

continuing to touch DISPENSE WATER (center button) after

each glass ll.

Measured Fill options are listed in the following chart:

Units

Ounces 8 16 32

Cups 1 2 4

Liters 0.2 0.5 1

NOTE: Most coffee cups (commonly 4 to 6 oz [118 to 177 mL]

per cup) are not the same size as a measuring cup (8 oz [0.2 L]).

You may need to recalibrate Measured Fill to underfill or to

avoid unintentionally overfilling coffee cups.

4. Dispense water.

NOTE: While dispensing water, the ow of water will

automatically stop once the desired volume has been

dispensed.

nPress a sturdy glass against the dispenser paddle below

the water spout.

nPlace the glass below the water spout and touch

DISPENSE WATER for hands-free dispensing.

5. To pause dispensing before the selected volume has been

dispensed, touch DISPENSE WATER a second time or touch

the water dispenser paddle. Touch DISPENSE WATER or

paddle again to resume dispensing remaining amount.

NOTE: If you stop dispensing before the desired volume has

been dispensed, the display will turn off after 1 minute. If you

have not resumed by then, it will reset back to the original

amount.

6. To select a new volume or start dispensing the same volume

again, you must rst nish dispensing the selected volume or

turn off the Measured Fill feature (either by waiting 1 minute,

so it will automatically turn off, or by touching CUBED ICE

or CRUSHED ICE to manually turn it off), and then select

Measured Fill again.

A. Water dispenser paddle

B. Ice dispenser paddle

C. Measuring cup (1 cup)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WQ9IMO1L Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WQ9IMO1L

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info