Bedienungsanleitung Whynter MSFS-009H11517-01NE (Seite 13 von 22) (Englisch)

727503

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

MODES OF OPERATION

When the delay time set has elapsed, the air conditioner switches off. To cancel the delayed switch off function, turn

off the air conditioner or adjust the time setting to 0.0.

NOTE: Timer ON and Timer OFF setting can be set at the same time.

SLEEP MODE FUNCTION

The SLEEP function is used to decrease energy use while you sleep. In this mode, the air conditioner gradually in-

creases the set temperature in cooling mode and decreases the set temperature in heating mode. In Sleep mode,

the set temperature is increased (cooling) or decreased (heating) by 1°C/ 2°F in the first 2 hours. This new tempera-

ture will remain the same for 5 hours, after which the air conditioner will automatically switch OFF. To activate this

function mode, press the SLEEP button on the remote control until the SLEEP indicator light comes on. This func-

tion can only be used in AUTO, COOL and HEAT modes.

NOTE: Changing function mode or fan speed will cancel the Sleep mode

AIR FLOW DIRECTION CONTROL

Air flow direction can be remotely controlled by pressing the SWING and DIRECT buttons on the remote control.

 Press the SWING button to activate auto-Swing mode. The horizontal air louvers will start moving up and down.

Pressing the SWING button again to cancel the auto-Swing mode and the air louver will stop. Press the DIRECT

button to change the louver movement and set the desired up/down air flow direction. The louver changes 6° in

angle for each press.

NOTES:

 A fixed louver angle in a high / horizontal angle is recommended for COOL and FAN modes for reaching across

the room.

 A fixed louver angle in a low / downward angle is recommended for HEAT and DRY modes to prevent creating

air draft effect on people.

 Never adjust the louvers by hand to prevent damage to the delicate driver motors.

 Manually adjust the deflector rods to direct the air to the right or left direction as desired. (see Fig. 1)

CAUTION:

 Do not operate the air conditioner for long periods with the air flow direction set downward in cooling or dehu-

midifying mode. Otherwise, condensation may occur on the surface of the horizontal louver causing moisture

to drop on to the floor or on furnishings. (see Fig. 2)

 When the air conditioner is started immediately after it was stopped, the horizontal louver might not move for

approximately 10 seconds.

 Open angle of the horizontal louver should not be set too small, as COOLING or HEATING performance may

be impaired due to too restricted air flow area.

 Do not move the horizontal louver manually, otherwise the horizontal louver will be out of sync. Turn off the

air conditioner for at least 3 minutes, then restart the unit.

 Do not operate unit with horizontal louver in closed position.

 Do not put your fingers in or near the blower and suction side of the unit. The high-speed fan inside the unit

may cause injury.

Fig. 1

Fig. 2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whynter MSFS-009H11517-01NE Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info