Bedienungsanleitung Wiking Volcanic 1 (Seite 26 von 52) (Deutsch, Englisch, Italienisch)

745740

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Make Sure there is the right Amount of Air in the Combustion Chamber

You should also make sure that there is an ample amount of air - especially in the beginning - so

that the temperature inside the wood-burning stove quickly rises. Gases and particles released

during burning are then more easily burned off. Otherwise, they gather as soot in the chimney

(which increases the risk of chimney re) or are emitted unburned into the atmosphere. The

wrong amount of air supply creates inefcient combustion and a modest effect.

Don’t Savour the Fire during Night Time

We advise against adding re wood to your stove and reducing the air supply at night in an at-

tempt to still have some embers left in the morning. If you do so, large amounts of hazardous

smoke will be emitted, and your chimney will be exposed to unnecessarily large amounts of

soot with the risk of a chimney re.

Lighting and Firing your WIKING Wood-Burning Stove

The First Firing

The rst time you re your wood-burning stove, you must do so carefully, as all materials

need to adjust to the heat. This means that the stove must be heated slowly, until it reaches

its maximum heat level. Afterwards, you should re a few times so that the stove is thoroughly

heated throughout.

Be Careful of the Lacquer

The lacquer used to treat the wood-burning stove will harden the rst 2-3 times the stove is

red, and this can create unpleasant smoke and odours. Ensure therefore that the room is well

ventilated. The door must also be carefully opened; otherwise there is a risk that the seals will

stick to the lacquer.

Warning: The enclosed gloves can scratch the surface paint if the lacquer has not hardened

properly. Be careful not to touch the lacquered surfaces until after the rst 2-3 rings.

Lighting

1. The damper is completely opened by pulling the lever beneath the door 20 mm towards

you.

2. Stack 8-10 nely split pieces of rewood, corresponding to 1-2 kg, inside the wood-

burning stove. The smaller the sticks, the shorter the time needed for the stove to be

heated and for the optimal combustion temperature to be achieved.

3. Place two relighters between the top layer of kindling. WIKING recommends using

high-quality relighters, as they do not produce smoke or odours.

4. Light the relighters. Keep the door ajar for a couple of minutes until the glass is hot

- this prevents condensation. Then close the door completely.

5. When the rewood is fully ignited, push the air damper in 10 mm so that it is halfway in.

This creates even and steady combustion.

Warning: The door may only be kept open when lighting, adding rewood or cleaning the

wood-burning stove; otherwise combustion becomes too powerful, which in turn increases the

risk of the stove becoming overheated.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wiking Volcanic 1 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wiking Volcanic 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info