809346
8
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
8
Installation
Comfort I – 6720810964 (2014/07)
Turn the knob to select Radio settings
Press the knob to display Pairing, that is RF pairing of the
devices in the system
Turn the knob to display Unpairing or Pairing
▶If Pairing is chosen, press the knob and pairing is displayed
with advancing bars.
When the pairing between the devices has been made the
number 1 is displayed confirming the Room thermostat is
connected
▶If Unpairing is chosen, press the knob and Unpairing is
displayed with advancing bars, when the unpairing
between the devices has been made the number 0 is
displayed confirming that the Room thermostat has been
disconnected
3.4.2 Room Thermostat - Settings- rF 1 Pair
To enter the Settings menu:
1. Press the knob until the two bars are displayed
2. Release the knob to enter the Settings menu
Fig. 5 Settings
The following sub-menus are available:
1. E 1 Room temperature sensor adjustment
2. F 1 Factory reset
3. rF 1 Pairing/Unpairing
4. S 1 Software version
5. S 2 RF signal strength indication
Turn the knob to select rF 1 and press
Turning the knob will display A or d
▶To Pair the Room thermostat with the Programmer/
Receiver, turn the knob to select A
Press the knob to start the pairing process, the
Programmer/Receiver has to be in the same mode.
During the pairing process 0 flashes until the units are
connected and then 1 will be displayed flashing, when the
pairing is completed A is displayed. Either wait 30 seconds and
the display will revert to displaying the current room
temperature, to move to the next higher level, press the knob
for more than three seconds and when the bars are displayed,
release the knob.
To leave the menu and display current room temperature,
press the knob again for more than three seconds and when the
bars are displayed, release the knob to display the current
room temperature.
▶To Unpair (disconnect) the units, turn the knob to select d
Press the knob to start the unpairing (disconnection), a 1
will be displayed flashing, when the unpairing is completed
a flashing 0 will be displayed and when the process is
complete, d is displayed
When the unit(s) have been unpaired or disconnected a
zero will be displayed indicating that no units are
connected.
Press the knob, for more than three seconds, to return to the
previous level, rF 1.
Press the knob until the three bars are displayed and release
the knob to display the current room temperature.
3.5 Room thermostat mounting
The Room thermostat is a radio frequency (RF) device and as
such is flexible for positioning, there is no requirement to hard
wire the device.
The Room thermostat requires free air flow and should be
mounted in an open area and not obscured by curtains or
furniture. The thermostat should be mounted no closer than
300mm to metal objects, including metal wall boxes.
Mount the thermostat on a wall that is not subject to direct
sunlight or draughts, preferably on an inside wall at 1.2 metres
above the floor.
If a fault code is displayed the user must first
press the knob to return to the main display then
the user can hold the knob to enter the Settings
menu
6720810964-17.1Wo
6720810964-12.1Wo
6720810964-08.1Wo
6720810964-09.1Wo
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Worcester-Bosch Greenstar Comfort I RF - 2014-2022 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info