Bedienungsanleitung Worcester-Bosch Greenstar Comfort II RF - 2014-2022 (Seite 16 von 20) (Englisch)

809344

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Receiver

Comfort II– 6720810965 (2014/07)

6Receiver

The Receiver is paired with the Programmable room

thermostat and they communicate via an RF signal. The

Receiver unit has an Override/Pairing push button and a LED to

indicate various sates of operation.

6.1 Override push button

If the RF signal between the Receiver and the Programmable

room thermostat is lost the LED, on the Receiver, will flash once

a second, indicating a local error (not a boiler fault).

During this time, the override push button can be briefly

pressed once (less than 3 seconds) to override the

Programmable room thermostat and maintain the boiler

function for heating and hot water.

During override the LED will be on but will flash off briefly to

indicate an override situation.

Press the override push button again briefly, to cancel the

override feature.

6.2 Pairing/Unpairing

If a unit becomes faulty and has to be replaced, then both units

will need to be unpaired. The replacement unit, when fitted,

and the original unit will need to be paired together.

Once the Programmer is in the unpairing mode, press the

override push button on the Receiver for more than 10 seconds

to put the Receiver in the unpairing mode.

The LED will flash five quarter second flashes at he beginning of

a five second period to indicate the unpairing function.

When the faulty unit has been unpaired, the replacement unit

can be fitted and paired with the Receiver.

Once the Programmer is in the pairing mode, press the Pairing

button [2] on the Receiver for more than five seconds but less

than 10 to enter the pairing mode. The LED [1] with flash two

quarter second flashes at the beginning of a five second period

to indicate the pairing function.

Fig. 16 Receiver

[1] LED (for flash codes refer to the table below)

[2] Override button/Pairing button

The Programmable room thermostat and

Receiver are delivered together and are

factory paired, they will automatically

connect when the system is switched on.

If the units have to be paired, all units must be

in the pairing mode to be connected, refer to

section 5.2 Radio settings for putting the

Programmable room thermostat into the mode.

Green indicator LED Indicates the status:

Normal

operation

OFF No central heating zone is

calling for heat

ON One or more zones calling for

heat

Manual

override

Flashing off, for

¼ second over a 2

second period

Manual override is active

Pairing

modes

2 x ¼ second flashes

over 5 a sec. period

Pairing in operation

5 x ¼ second flashes

over 5 a sec. period

Unpairing in operation

Push

button

Press for >5 seconds

for pairing

Press for >10 sec. for

unpairing

Pairing or unpairing the

Receiver with the

Programmable room

thermostat(s)

Press once, briefly, for

override, press again

for no override

Manually switching the boiler

ON or OFF

Table 1 Receiver LED flash codes

6720810965-15.1Wo

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Worcester-Bosch Greenstar Comfort II RF - 2014-2022 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info