Bedienungsanleitung Workzone EP2800i (Seite 11 von 21) (Englisch)

724636

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

Digital Inverter Generator with Pure Sine Wave

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. EP2800i • 09/2018 • 62007

(toll free)

AFTER SALES SUPPORT

(toll free)

Digital Inverter Generator with Pure Sine Wave

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. EP2800i • 09/2018 • 62007

18 19

1. Before checking or relling oil, be sure the

generator is put on a stable and level surface,

ensuring the engine has been switched OFF.

When lling with oil you can lift the generator

approximately 100 mm at the front (Fig G),

however the generator must be sitting at back on

its feet when checking the level of oil using the oil

ller cap/dipstick (12).

Make sure you check the capacity of fuel tank

before checking the oil level. The fuel tank

(26) should be less than 50% full when the

generator is tilted by 100mm to ll the oil

reservoir, or fully drained if the generator is

tilted more than 100mm.

2. Remove the oil ller cap/dipstick (12)

by rotating the cap in an anti-clockwise

direction, and wipe all oil residue o the oil

ller cap/dipstick (12) with a clean rag.

Re insert the oil ller cap/dipstick (12) and

thread the cap fully in position.

Then remove the oil ller cap/dipstick (12) by rotating in an anti clockwise

direction and view the oil level on the oil ller cap/dipstick (12).

3. If the oil level is close to or below the lower level line, rell using the supplied

oil bottle (32) with 4 stroke oil to the upper level line (Fig H).

Do not use the generator when the oil level is close to the low level. Fill the

oil tank before use each time.

4. If the oil is contaminated or has discoloured, ensure you change the oil.

Replace the oil ller cap/dipstick (12). DO NOT start the generator with the

oil Filler cap/dipstick (12) not rmly replaced.

NOTE: This engine is tted with a low oil indicator light (4). If the oil level

is too low the engine will stop operating or the engine will not start. It is

advised to check the oil level each time the generator is used and ll to the

upper mark on the oil ller cap/dipstick (12) by the above method.

Do NOT over ll.

Preparation Information Preparation Information

WARNING.

• Do not rell fuel tank (26) while engine is running or is hot.

• Check to ensure that the fuel drain (10) has been tightened and that fuel is

not leaking.

• Be careful not to admit dust, dirt, water or other foreign objects into the fuel.

• Wipe o spilt fuel thoroughly before starting engine.

• Ensure you DO NOT fuel the generator in close proximity to any open

ames, lit cigarettes, or hot objects.

• The generator should also be located in an open area with fresh air and NOT

in a conned area.

WARNING: Ensure the engine is switched o while undertaking

this task.

1. Remove the fuel tank cap (27) by rotating in an anticlockwise direction.

2. Remove the fuel tank inlet lter (24) and ensure it is clean and free of debris.

Check the level of fuel is sucient.

3. If the fuel tank inlet lter (24) was removed to check the fuel level, ensure it

is replaced back before adding fuel.

4. To add fuel, pour the unleaded fuel from an approved fuel container into the

fuel tank (26). As fuel expands, DO NOT FILL to the lip of the tank. Maximum

ll is to the top of the fuel tank inlet lter (24) rim.

5. Replace fuel tank cap (27) turning in a clockwise direction to lock.

Filling and checking the Engine oil

The engine of this generator is NOT lled with oil when unpacked.

Prior to starting the engine ensure the oil tank is lled with SAE 10W-30

4 stroke oil. For the rst time ll the engine should be lled with 550ml

(+/-10%) of SAE 10W-30 oil. We recommend GARDENLINE® Full Synthetic

4 Stroke Oil.

NOTE: Damage to the engine is not covered under warranty if the engine is

run with insucient oil.

NOTE: Ensure the fuel tank cap (27) is secure before attempting to add oil.

UPPER

MARK

LOWER

MARK

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Workzone EP2800i Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info