Bedienungsanleitung Workzone EP2800i (Seite 12 von 21) (Englisch)

724636

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

Digital Inverter Generator with Pure Sine Wave

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. EP2800i • 09/2018 • 62007

(toll free)

AFTER SALES SUPPORT

(toll free)

Digital Inverter Generator with Pure Sine Wave

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. EP2800i • 09/2018 • 62007

20 21

Starting your Generator

NOTE: As the oil tank is not shipped with oil before starting the engine,

ensure you have lled the oil tank to the correct level with oil, and make sure

fuel has been added to the fuel tank (26).

1. Before starting, check to ensure the 240Va.c Outlet Power On/O switch

(1 ) is in the right hand side “OFF” position, and ensure that no electrical

appliance is connected to the generator by removing any appliance cords

from the outlets (Fig. K/L).

2. Turn the fuel tap / lever (23) clockwise to the ‘ON’ position (Fig. M).

When vertical it is in the correct position.

3. Push the choke lever (16) towards the front of the generator to the full

choke “START” position (Fig. M). Choke is not necessary if the engine is

already warm and you’re restarting. The direction for the choke is also

indicated below the choke lever (16) on the air lter cover (17).

Operation Operation

K. L.

OFF

Engine oil replacement

1. Place the generator on a at and level surface and

warm up the engine for several minutes. Then stop

the engine.

2. Place an oil pan at the front of the generator

ensuring it is in front of the oil ller cap/dipstick

(12) area. Commence removing the oil ller cap/

dipstick (12) by rotating in an anti clockwise

direction to remove, so that the oil can be

completely drained from the oil reservoir.

WARNING: Oil may be warm to hot. It is recommended to wear gloves

for protection.

3. Tilt the generator forwards (Fig I), so that the oil can drain from the oil

reservoir into the oil pan.

4. Reinstall the oil ller cap/dipstick (12) and rotate in a clockwise direction

until secure.

5. Refer to the previous instructions on page 18 for “Filling and checking the

engine oil” to rell the oil reservoir.

CAUTION. Check that no foreign material, debris, dust enters the crankcase.

6. Ensure to replace the oil ller cap/dipstick (12) after relling with fresh oil by

securing it in a clockwise direction.

RUN

FRONT OF GENERATOR

START

OFF

Operation

Before Starting your Generator Economy mode

This inverter generator is tted with an economy

switch (29).

When the economy switch is turned on (Fig J),

the speed of the generator motor is reduced, thus

reducing fuel consumption, noise and ware and tear.

This economy setting is suitable for all low current

draw appliances.

In the event a larger appliance is turned on, the speed of the generator is

automatically increased to maintain a constant output.

Where a large appliance is known to be used, it is always better to turn the

Eco Switch to the OFF position so the sudden increase in power requirement

is not eected with the speed of the motor building up to speed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Workzone EP2800i Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info