Robosapien has three programmable sensors and a
Master program, that allows you to take control of the
following unique programming environments:
1) Right Sensor Program ( )#16
2) Left Sensor Program ( )#18
3) Sonic Sensor Program ( )#17
4) Master Program ( )#19
• Touch Sensors:
The sensors on Robosapien's Fingers, Toes and Heels
can all be programmed to respond when touched.
They also trigger whenever he walks into an obstacles.
• Right & Left Sensor Programs:
a) Ensure the Controller is in normal mode (indicator light on Controller is DARK).
b) Press the Right or Left Sensor Program button once (Robosapien beeps - you are now in program
mode).
c) Program up to six steps (the Select button does not count as step). For example:
Walk Forward, Right Arm Out, Left Arm Out, (SELECT, SELECT, ROAR), Tilt Body Right, Tilt Body Left.
d) Robosapien will now automatically repeat your programmed sequence.
e) If you wish to program less than six steps, you need to 'close' the program by pressing PROGRAM PLAY
( ) once, after you've completed your selection - for example:
Walk Forward, Turn Right, ( ) High 5, PROGRAM PLAY ( ).
f) To trigger the sensor, touch a long finger, or a toe/heel sensor (on the side corresponding to the sensor
program you set). Alternatively press SELECT once (GREEN command mode), followed by R> or L>
Sensor Program Execute (depending on which side has been programmed) and he'll also run through
the routine.
• Clearing the Program/Holding the Program:
a) To clear the program and return to the Default program, press the Right, or Left Sensor Program button
once, followed by the Program Play button and the program will clear.
b) Turning Robosapien off will also clear any previously set programs.
c) Use the Sleep function to hold the program in Robosapien's memory for up to two hours.
P.13
Programming Mode - touch sensors
