General Care and Troubleshooting WorkCentre
®
5845/5855/5865/5875/5890
680 User Guide
Repeated Check Tray messages
• Adjust the edge guides against the stack of paper in the tray.
• If the edge guides were not set against the paper in the tray when Start was selected, delete
the job in the job queue and begin again.
If everything appears correct but the problem persists turn the device off, wait 2 minutes and then
switch it back on again.
More Information
Loading Tray 1 and Changing the Tray Settings
Loading Tray 2 and Changing the Tray Settings
Loading Tray 3
Loading Tray 4
Loading Tray 5 (Bypass Tray) and Changing the Tray Settings
Loading Tray 6
Paper curls
• Load the paper in the paper trays with the seam side of the paper up. Load the paper in the
Bypass Tray with the seam side down.
• Load non-standard media in the Bypass Tray.
• If the paper curls excessively, flip the paper over in the applicable paper tray.
More Information
Storing Paper and Other Media
Loading Tray 1 and Changing the Tray Settings
Loading Tray 2 and Changing the Tray Settings
Loading Tray 3
Loading Tray 4
Loading Tray 5 (Bypass Tray) and Changing the Tray Settings
Loading Tray 6
The finisher does not stack the output correctly
• Unload the finisher tray frequently.
• Do not remove stapled sets while the finisher is compiling.
• Check the paper tray guides are locked into position against the paper.
• When using large paper, remove any output contained in the Stacker Tray.
• Load the paper in the paper trays with the seam side of the paper up. Load the paper in the
Bypass Tray with the seam side down.
• Load non-standard media in the Bypass Tray.
• If the paper curls excessively, flip the paper over in the applicable paper tray.
• Check the correct paper size has been selected for the paper loaded in the tray.
• Check the correct paper type, such as the weight, has been selected for the paper loaded in the
tray.
More Information
Loading Tray 1 and Changing the Tray Settings
