Bedienungsanleitung Yamaha EX5 (Seite 179 von 304) (Englisch)

48736

179

Zoom out

Zoom in

Vorherige Seite

1/304

Nächste Seite

179

Sample Mode

Sample Edit Mode

In the Sample Edit mode, you can edit samples

recorded in the Sample Record mode to put them into

the final form as you like.

Press [EDIT] key on the panel while in Sample mode to

enter Sample Edit mode. You cannot enter Sample Edit

mode, if the targeted sample number (in RAM bank)

contains no data. When you enter the Sample Edit

mode, the following sub menu below will be displayed.

There are the next three types of settings available.

Press [F6]~[F8] to select the necessary menu.

[F6]: PARAM (Settings related to playing back samples)

[F7]: LOOP (Settings related to the sample loop)

[F8]: NAME (Settings for naming samples)

In the [F6]: PARAM and [F7]: LOOP screens, [F1]:

KNx*(Knob x [unit]) and [F4]: LP. LOCK (Loop Lock) will

be added. In the [F7]: LOOP screen, [F3]: ZOOM* will also

be added. For the information about each item see the

respective explanations below.

Before entering the Sample Edit mode, it is first necessary

to select the sample that you want to edit in Sample Play

mode (page 175). All parameters can be applied to each

sample. After you have finished editing, remember to save

to floppy disk or an external storage device.

When the power is turned off, the data in the internal

memory is erased. Remember to save important sample data

to floppy disk or an external storage device (page 259).

The sample recorded as stereo data can be edited in stereo.

However, if you combine and set the different two samples

as L/R data, you cannot enter Sample Edit mode.

[F6]: PARAM (Parameter)

There are various parameters for setting the most basic

aspects of sample playback, such as setting the wave

Start/End point as well as how the sample will sound.

F6 F7 F8

■ Wave Type

Displays the sample wave type. The sampling

frequency for a sample recorded on the EX5/5R/7 is

fixed at 16 bit linear/44.1 KHz.

The EX5/5R/7 can load and play back the WAV, AKAI

and AIFF format files. In this case, a wave type other

than 16 bit linear/ 44.1KHz such as 12 bit linear, 8 bit

linear and 8 bit LPC (compressed) may be displayed.

For more information on loading sample files, see page

263.

■ Center key

Assigns the original pitch of the sample to a key on

the keyboard. Using this assigned key as the center

pitch, you can raise or lower the pitch in semitones

and play back the sample.

❏ Settings: C–2~G8

■ LoopTune

Finely adjusts the pitch of the loop section for

playback.

❏ Settings: –63~0~+63

■ SmplPlay (Sample Play)

Switches how the sample is played back. There are

four choices: “FwdLp,” “FwdLpEx,” “FwdNoLp” or

“RevNoLp.”

❏ Settings:

FwdLp:

While a key is pressed (held down), the sample playback

begins from the Start point, moves to the Top point and

then repeats continuously from the Top point to the End

point.

Keyboard

If the sample’s original pitch is “C4” and

the Center key is designated to “F4”

C4 D4 E4 F4 G4 A4 B4

4F4

G3 A3 B3 C4 D4 E4 F

Actual pitch

Sample/E/qx 5/21/98 11:39 AM Page 179

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha EX5 Seite 179

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha EX5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info