Bedienungsanleitung Yamaha MOTIF ES7 (Seite 203 von 300) (Englisch)

571272

203

Zoom out

Zoom in

Vorherige Seite

1/300

Nächste Seite

Reference Voice Mode

Voice Edit mode Drum Voice Edit Key Edit

203

Owner’s Manual

Category Determines the Category of the Wave/Normal Voice. If you switch to another Category, the ﬁrst Wave/Normal Voice in

that Category will be selected.

nFor more information about the Categories, refer to the separate Data List booklet.

[SF2] OUTPUT From this display you can set certain output parameters for the selected Drum key.

InsEFOut

(Insertion Effect Output) Determines which Insertion effect (A or B) is used to process each individual Drum key. The “thru” setting lets you

bypass the Insertion effects for the speciﬁc key.

Settings: thru, insA (Insertion Effect A), insB (Insertion Effect B)

RevSend (Reverb Send) Determines the level of the Drum key sound (the bypassed signal) that is sent to Reverb effect. A setting of “0”

results in no Reverb processing of the Drum key sound. This is available only when Insertion Effect Output (above) is

set to “thru.”

Settings: 0 ~ 127

ChoSend (Chorus Send) Determines the level of the Drum key sound (the bypassed signal) that is sent to Chorus effect. A setting of “0”

results in no Chorus processing of the Drum key sound. This is available only when Insertion Effect Output (above) is

set to “thru.”

Settings: 0 ~ 127

OutputSel (Output Select) Determines the speciﬁc output(s) for the individual Drum key signal. You can assign each individual Drum key sound

to be output from a speciﬁc hardware output jack on the rear panel. This is available only when Insertion Effect

Output (above) is set to “thru.”

Settings: See page 31.

[SF5] OTHER From this display you can set various parameters related to how the individual notes of the Drum voice respond to

the keyboard and MIDI data.

AssignMode When this is set to “single,” double playback of the same note is prevented. This is useful when two or more

instances of the same note are received nearly simultaneously, or without a corresponding note off message. To

allow playback of each instance of the same note, set this to “multi.”

Settings: single, multi

RcvNoteOff (Receive Note Off) Determines whether or not the selected Drum key responds to MIDI Note Off messages.

Settings: off, on

nThis parameter is available when the Type is set to “pre wav” or “usr wav” in the [F1] OSC → [SF1] WAVE display (page 202).

AlternateGroup Set the Alternate Group to which the key is assigned. In a real drum kit, some drum sounds cannot physically be

played simultaneously, such as open and closed hi-hats.You can prevent keys from playing back simultaneously by

assigning them to the same Alternate Group. Up to 127 Alternate Groups can be deﬁned. You can also select “off”

here if you wish to allow the simultaneous playback of sounds.

Settings: off, 1 ~ 127

[F2] PITCH

[SF1] TUNE From this display you can set various pitch-related parameters for the selected key.

Coarse Determines the pitch of each Drum Key Wave (or Normal Voice) in semitones.

Settings: -48 ~ +48

If a Normal voice has been assigned to the key, this parameter adjusts the position of its note (not its pitch) relative to note C3.

Fine Determines the ﬁne tuning for the pitch of each Drum Key Wave (or Normal Voice).

Settings: -64 ~ +63

[SF2] VEL SENS

(Velocity Sensitivity)

Pitch Determines how the pitch of the selected Drum key responds to velocity. For positive values, the more strongly you

play the key, the higher the pitch becomes. For negative values, the more strongly you play the key, the lower the

pitch.

Settings: -64 ~ +63

[F3] FILTER

[SF1] CUTOFF This synthesizer lets you apply a low pass ﬁlter and high pass ﬁlter to each individual Drum key — giving you

exceptionally detailed and comprehensive sonic control over the Drum voice.

Settings: This parameter is available when the Type is set to “pre wav” or “usr wav” in the [F1] OSC → [SF1] WAVE display (page 202).

LPFCutoff Determines the Cutoff frequency of the Low Pass Filter.

Settings: 0 ~ 255

LPFReso Determines the amount of Resonance (harmonic emphasis) applied to the signal at the Cutoff frequency.

Settings: 0 ~ 127

HPFCutoff Determines the Cutoff frequency of the High Pass Filter.

Settings: 0 ~ 255

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha MOTIF ES7 Seite 203

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha MOTIF ES7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info