From this display you can make various time and level settings for the Pitch EG, which determine how the pitch of the Plug-in Voice changes over time.
The full names of the available parameters are shown in the chart below, as they appear in the display.
[F3] FILTER
HPFCutoff (High Pass Filter
Cutoff frequency)Determines the Cutoff frequency for the High Pass Filter.
Settings:-64 ~ 0 ~ +63
[F4] NATIVE
With a Plug-in board installed to this synthesizer, you can create a Plug-in Voice by editing both native parameters (those parameters exclusive to the particular
board) and unique parameters (related specifically to this synthesizer).
Pressing [F4] gives you access to the native parameters of the Plug-in board. The parameters will vary depending on the Plug-in Board. For details about each
parameter and its functions, refer to the Owner’s Manual or the on-line help that came with your Plug-in Board.
[F5] LFO (Low Frequency Oscillator)
From this display you can set the basic LFO parameters for modulating the pitch to create vibrato and other special effects.
SpeedDetermines the speed of the LFO waveform. Positive settings increase the speed and negative settings decrease it.
Settings:-64 ~ 0 ~ +63
DelayDetermines the delay time between the moment you press note on the keyboard and the moment the LFO comes
into effect. Positive settings lengthen the delay and negative settings shorten it.
Settings:-64 ~ 0 ~ +63
PMod (Pitch Modulation Depth)Determines the amount by which the LFO waveform controls the pitch. Positive settings increase the amount and
negative settings decrease it.
Settings:-64 ~ 0 ~ +63
[F6] EQ (Equalizer)
From this display you can apply equalizer settings to the Plug-in Voice. This is a shelving equalizer with
two bands; one for high frequencies and the other for low frequencies.
nFor details on the EQ, see page 178.
LowFreq (Low Frequency)Determines the shelving point for the low frequencies. The levels of signals below this frequency will be boosted/
attenuated by the amount set in the LowGain parameter.
Settings:32Hz ~ 2.0kHz
LowGain (Low Gain)Determines the amount by which signals below the LowFreq frequency will be boosted/attenuated.
Settings:-64 ~ 0 ~ +63
HighFreq (High Frequency)Determines the shelving point for the high frequencies. The levels of signals above this frequency will be boosted/
attenuated by the amount set in the HighGain parameter.
Settings:500Hz ~ 16.0kHz
HighGain (High Gain)Determines the amount by which signals above the HighFreq frequency will be boosted/attenuated.
Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.
Art des Missbrauchs:
Forenregeln
Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:
Lesen Sie zuerst die Anleitung;
Schauen Sie nach, ob die Frage bereits gestellt wurde;
Stellen Sie die Frage so deutlich wie nur einigermaßen möglich;
Erwähnen Sie was Sie bereits versucht haben um das Problem zu lösen;
Ist Ihr Problem von einem Besucher gelöst dann lassen Sie ihn / sie wissen in diesem Forum;
Falls Sie reagieren möchten, so verwenden Sie bitte das Antworten- Formular;
Da ihre Frage für alle Besucher sichtbar ist, sollten Sie lieber keine persönliche Daten erwähnen.
Neu registrieren
Registrieren auf E - Mails für Yamaha MOTIF ES7 wenn:
neue Frage gestellt werden
neue Handbücher vorhanden sind
Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.
Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.
Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.
Ihre Frage wurde zu diesem Forum hinzugefügt
Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.