Bedienungsanleitung Yamaha MOTIF XS7 (Seite 101 von 320) (Englisch)

586887

101

Zoom out

Zoom in

Vorherige Seite

1/320

Nächste Seite

Editing a Normal Voice

MOTIF XS Owner’s Manual 101

Voice mode

Song mode

Pattern mode

Mixing mode

Master mode

Utility mode

File mode Performance

mode

Sampling

mode 1

Sampling

mode 2

Reference

Arpeggio settings—[F2] ARP Main

(Arpeggio Main)

This display determines the basic settings of the Arpeggio.

Keep in mind that parameters Bank (!) through Gate Time

Rate Offset (^) have ﬁve settings which can be edited in

each of the [SF1] ARP1 through [SF5] ARP5 displays.

For details about Arpeggio, see page 62.

nDepending on the selected parameter, the KBD icon appears

on the tab corresponding to the [SF6] button. In this condition,

you can enter the note number or velocity by pressing the

appropriate note on the keyboard while holding the [SF6] KBD

button. For details, see page 82.

1Switch

Determines whether Arpeggio is on or off. When calling up

a Voice for which the Common Switch is set to on, the

[ARPEGGIO ON/OFF] button on the panel will be turned on

automatically.

Settings: on, off

2Hold*

When this is set to “on,” the Arpeggio cycles automatically,

even if you release your ﬁngers from the keys.

Settings: sync-off (see below), off, on

sync-off

When set to “sync-off,” the Arpeggio playback continues to run silently,

even when you release the keys. Pressing any key turns the Arpeggio

playback on again, and the Arpeggio is heard from the point in the

cycle where playback is resumed.

3Change Timing*

Determines the actual timing at which the Arpeggio type is

switched when you select another type during Arpeggio

playback. When set to “realtime,” the Arpeggio type is

switched immediately. When set to “measure,” the

Arpeggio type is switched at the top of the next measure.

Settings: realtime, measure

4Velocity Limit

Determines the lowest and highest velocity which can

trigger the Arpeggio playback. This lets you set the velocity

range with which you press the note to trigger the Arpeggio

playback. You can also create separate low and high

trigger ranges for the Arpeggio playback, with a velocity

“hole” in the middle, by specifying the maximum value ﬁrst.

For example, setting a Velocity Limit of 93 – 34 lets you play

the Arpeggio from two separate velocity ranges: soft (1 –

34) and hard (93 – 127). Notes played at middle velocities

between 35 and 92 do not play the Arpeggio.

Settings: 001 – 127

5Note Limit

Determines the lowest and highest notes in the Arpeggio’s

note range. Notes played in this range trigger the

Arpeggio. For example, setting a Note Limit of “C5 – C4”

lets you trigger the Arpeggio by playing notes in the two

ranges of C -2 to C4 and C5 to G8; notes played between

C4 and C5 have no effect on the Arpeggio.

Settings: C -2 – G8

nPlease keep in mind that no sound is produced when the Key

Mode is set to “sort” or “thru” and notes are played outside the

Note Limit setting here.

6Tempo*

Determines the Arpeggio Tempo. This parameter can be

changed via the Knob directly.

Settings: 5 – 300

nIf you are using this instrument with an external sequencer,

MIDI computer, or other MIDI device, and you want to

synchronize it to that device, set the MIDI sync (5) parameter

in the MIDI display (page 268) of the Utility mode to “MIDI” or

“auto.” In this case, the Tempo parameter here indicates

“MIDI” or “auto” and cannot be changed.

7Key Mode

Determines how the Arpeggio plays back when playing the

keyboard.

Settings: sort, thru, direct, sort+direct, thru+direct

sort

When you play speciﬁc notes (for example, the notes of a chord), the

same sequence plays, no matter what order you play the notes.

thru

When you play speciﬁc notes (for example, the notes of a chord), the

resulting sequence differs depending on the order of the notes.

direct

Note events of the Arpeggio sequence do not play; only the notes you

play on the keyboard are heard. When the Arpeggio plays back, the

events such as Pan and Brightness are applied to the sound of your

keyboard performance. Use this setting when the Arpeggio types

includes non-note data or when the Category type “Ctrl” is selected.

sort+direct

The Arpeggio is played back according to the “sort” setting here, and

the note pressed is also sounded.

thru+direct

The Arpeggio is played back according to the “thru” setting here, and

the note pressed is also sounded.

nSome Arpeggio types belonging to the “Cntr” Category may

not have note events (page 65). When such an Arpeggio type

is selected and the Key Mode is set to “sort” or “thru,” no

sound is produced even if you press a note on the keyboard.

)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha MOTIF XS7 Seite 101

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha MOTIF XS7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info