Bedienungsanleitung Yamaha MOTIF XS7 (Seite 110 von 320) (Englisch)

586887

110

Zoom out

Zoom in

Vorherige Seite

1/320

Nächste Seite

Editing a Normal Voice

MOTIF XS Owner’s Manual

110

Voice mode Song mode Pattern mode Mixing mode Master mode Utility mode File mode

Performance

mode

Sampling

mode 1

Sampling

mode 2

Reference

1Type

Determines whether or not the Vocoder is applied to the

current Voice. When set to “Thru,” the Vocoder is not

applied to the Voice.

Settings: Thru, Vocoder

2Vocoder Attack

Determines the attack time of the Vocoder sound. The

higher the value, the slower the attack.

Settings: 1ms – 200ms

3Vocoder Release

Determines the release time of the Vocoder sound. The

higher the value, the slower the decay.

Settings: 10ms – 3000ms

4Mic Gate Threshold

Determines the threshold level of the noise gate for the

microphone sound. If noise interferes with the Vocoder

effect, set this parameter to a relatively high value to

prevent noise from producing inadvertent, unexpected

sounds.

Settings: -72dB – -30dB

5Gate Switch

Determines whether or not the microphone sound will be

output from the HPF while you release the notes. Normally,

set this to “on.”

Settings: off, on

off: The microphone sound always will be output. (You can always hear

the microphone sound.)

on: The microphone sound will be output only while pressing the note.

6HPF Freq (High Pass Filter Frequency)

Determines the HPF cutoff frequency for the microphone

input sound. Setting this to a low value results in a

minimally processed input sound—in other words, close to

the original. Setting this to higher values emphasizes the

higher frequency consonant and sibilant sounds (which

make words easier to understand).

Settings: thru, 500Hz – 16.0kHz

7HPF Output Level

Determines the level of the microphone sound output from

the HPF (High Pass Filter).

Settings: 0 – 127

8Formant Shift

Determines the amount (in BPF) by which the cutoff

frequency value of the BPFs (for the Inst Input) is shifted.

This parameter can be used to adjust the pitch of the

Vocoder sound.

Settings: -2, -1, +0, +1, +2

9Formant Offset

Adjusts the cutoff frequencies of all BPFs (for the Inst Input)

ﬁnely. This parameter can be used to adjust the pitch of the

Vocoder sound ﬁnely.

Settings: -63 – +0 – +63

)Mic Level

Determines the microphone sound level, which is to be

input to the Vocoder.

Settings: 0 – 127

!Inst Input Level

Determines the level of the keyboard performance sound,

which is to be input to the Vocoder.

Settings: 0 – 127

@Noise Input Level

Determines the noise level which is input to the Vocoder.

This can be used to emphasize sibilant and plosive

sounds, and make the speech-like characteristics more

pronounced.

Settings: 0 – 127

#Output Level

Determines the output level of the Vocoder.

Settings: 0 – 127

$Dry/Wet Balance

Determines the balance between the dry sound to which

the effect is not applied and the wet sound to which the

effect is applied. The higher the W setting, the deeper the

effect.

Settings: D63>W – D=W – D<W63

%BPF1 – 10 Gain (Band Pass Filter 1 – 10 Gain)

Determines each output gain of the BPF 1 – 10 for the Inst

Input (keyboard performance sound). The BPF1

corresponds to the lowest Formant while the BPF 10

corresponds to the highest Formant.

Settings: -18dB – +18dB

)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha MOTIF XS7 Seite 110

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha MOTIF XS7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info