Bedienungsanleitung Yamaha XV920 Virago (Seite 310 von 363) (Englisch)

689861

310

Zoom out

Zoom in

Vorherige Seite

1/363

Nächste Seite

Chapter 8 Part A Electrical system (XV535 models) 8A-7

11.3 The turn signal relay/cancel unit is

located behind the right front side cover;

it's part of the relay assembly and can be

identified by its wire colors

12.5 To remove the brake light switch,

insert a tool into the hole under the

bracket and release the retainer

12.8 Disconnect the brake light switch

spring, loosen the locknut and compress

the prongs to detach the switch from

the bracket

11 Turn signal circuit - check

Refer to illustration 11.3

1 The battery provides power for operation of the signal lights, so if

they do not operate, always check the battery voltage and specific

gravity first. Low battery voltage indicates either a faulty battery, low

electrolyte level or a defective charging system. Refer-to Chapter 1 for

battery checks and Sections 26 and 27 for charging system tests.

Also, check the fuses (see Section 5).

2 Most turn signal problems are the result of a burned out bulb or

corroded socket. This is especially true when the turn signals function

properly in one direction, but fail to flash in the other direction. Check

the bulbs and the sockets (see Section 10).

3 If the bulbs and sockets check out okay, remove the right front

side cover and check for power at the turn signal relay in the relay

assembly (see illustration) with the ignition On. Refer to the Wiring

diagrams at the end of the book to identify the power source terminal.

4 If the relay is okay, check the wiring between the turn signal relay

and the turn signal lights (see the wiring diagrams at the end of the

book).

5 If the wiring checks out okay, replace the turn signal relay.

12 Brake light switches - check and replacement

Circuit check

1 Before checking any electrical circuit, check the fuses (see

Section 5).

2 Using a test light connected to a good ground, check for voltage

at the brake light switch. If there's no voltage present, check the wire

between the switch and the fuse box (see the wiring diagrams at the

end of this Chapter).

3 If voltage is available, touch the probe of the test light to the other

terminal of the switch, then pull the brake lever or depress the brake

pedal - if the test light doesn't light up, replace the switch.

4 If the test light does light, check the wiring between the switch

and the brake lights (see the wiring diagrams at the end of this

Chapter).

Switch replacement

Front brake lever switch

Refer to illustration 12.5

5 The switch slides into the handle pivot and is secured by a prong

(see illustration). Disconnect the electrical connector. Insert a small

13.1 Unscrew the speedometer cable from the speedometer (A);

note the mounting bracket attachment (B)...

screwdriver or probe into the release hole on the underside of the lever

bracket, press up on the retaining prong and pull out the switch.

6 Installation is the reverse of the removal procedure. The brake

lever switch isn't adjustable.

Rear brake pedal switch

Refer to illustration 12.8

7 Unplug the electrical connector in the switch harness.

8 Unhook the switch spring (see illustration).

9 Compress the retainer prongs and slide the switch out of the

bracket (see illustration 12.8).

10 Install the switch by reversing the removal procedure, then adjust

the switch by following the procedure described in Chapter 1.

13 Speedometer and cable - removal and installation

Speedometer cable removal

Refer to illustrations 13.1 and 13.2

1 Unscrew the speedometer cable end and pull the cable from the

speedometer (see illustration). If necessary for access, lower the

headlight assembly (see Section 9).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha XV920 Virago Seite 310

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info