Bedienungsanleitung Yamaha YHT-594 (Seite 10 von 12) (Englisch)

554705

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

8 En

If this product doesn’t work as expected, look for a possible cause below. If the issue you are experiencing is not listed, or you cannot

resolve it after reading through these instructions, disconnect the power cable and contact an authorized Yamaha dealer or service

center.

■ Subwoofer (NS-SW280)

■ Surround speakers (NS-B285)

Type ........................................... Full-range acoustic-suspension

non-magnetic shielding type

Driver............................................ 6.5 cm (2-1/2") cone speaker

Nominal input power ......................................................... 30 W

Maximum input power ...................................................... 80 W

Impedance ............................................................................... 6 Ω

Frequency response........................................... 110 Hz–40 kHz

Sensitivity ........................................................81 dB/2.83 V, 1 m

Dimensions (W × H × D)

................ 90 × 90 × 109 mm (3-1/2" × 3-1/2" × 4-1/4")

(without stand)

.............. 90 × 120 × 123 mm (3-1/2" × 4-3/4" × 4-7/8")

(with stand)

Wei ght ........................................0.45 kg (1 lbs.) (without stand)

■ Front/center speaker (NS-BR300)

Type ........................................... Full-range acoustic-suspension

non-magnetic shielding type

Driver....................... 4 × 10 cm (1-1/2 × 4 in) cone speaker ×3

Frequency response........................................150 Hz to 20 kHz

Impedance ............................................................................... 6 Ω

Dimensions (W × H × D)

NS-BR300 ........... 800 × 50 × 70 mm (31-1/2" × 2" × 2-3/4")

Stand................. 45 × 70 × 88 mm (1-3/4" × 2-3/4" × 3-1/2")

Wei ght ...................................................................... 1.5 kg (3 lbs.)

■ Subwoofer (NS-SW280)

Type

........................ Advanced

Ya m a h a

Active Servo Technology

Driver...............................................16 cm (6-1/2") cone woofer

non-magnetic shielding type

Output power........................ 50 W (100 Hz, 5 Ω, 10% T.H.D.)

Dynamic power ......................................................... 100 W, 5 Ω

Input impedance

....................INPUT (1P RCA pin jack): 10 kΩ

Frequency response .............................................30 Hz–160 Hz

Input sensitivity............................. INPUT (1P RCA pin jack):

80 mV (50 Hz, 50 W/5 Ω)

Power supply

U.S.A. and Canada models...........................AC 120 V, 60 Hz

Australia model..............................................AC 240 V, 50 Hz

U.K. and Europe models...............................AC 230 V, 50 Hz

Dimensions (W × H × D) ........................262 × 264 × 316 mm

(10-3/8" × 10-3/8" × 12-1/2")

Weig ht ................................................................. 6.9 kg (15.2 lbs.)

■ Speaker stand (SPS-90)

Dimensions (D × H)

.............. Φ 230 × 910 mm (Φ 9" × 35-7/8") (Shortest)

............... Φ 230 × 1200 mm (Φ 9" × 47-1/4") (Tallest)

Weig ht .............................................................. 2.2 kg (4 lbs 7 oz)

Specifications are subject to change without notice.

Troubleshooting

Issue Possible cause Remedy

There’s no sound. The speaker cables are not

connected properly.

Make sure the speaker cables are connected properly.

The sound is very quiet. The speaker cables are not

connected properly.

Make sure the speaker cables are connected properly:

L (left) to L, R (right) to R, “+” to “+” and “–” to “–”.

Issue Possible cause Remedy

The POWER switch is set to ON but

the subwoofer doesn’t work.

The power cable is not connected

properly.

Set the POWER switch to OFF, then make sure the power

cable is connected properly.

There’s no sound. The VOLUME control is set to 0. Turn up the VOLUME control.

The subwoofer cable is not

connected properly.

Make sure the subwoofer cable is connected properly.

The subwoofer is too quiet. The source material doesn’t

contain much bass.

Try playing source material that contains more bass.

Bass sounds are being cancelled

out by standing waves.

Reposition the subwoofer, or break up parallel wall surfaces

by placing bookshelves or other large objects along the wall.

Specifications

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha YHT-594 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha YHT-594

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info