Bedienungsanleitung Yard Machines TRACTOR 42SD 1650S 5STY - 13AN775S000 (Seite 19 von 68) (Englisch)

522631

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

19Section 5 — operation

Mowing

WARNING! To help avoid blade contact or a

thrown object injury, keep bystanders, helpers,

children and pets at least 75 feet from the machine

while it is in operation. Stop machine if anyone

enters the area.

The following information will be helpful when using the cutting

deck with your tractor:

WARNING! Plan your mowing pattern to avoid

discharge of materials toward roads, sidewalks,

bystanders and the like. Also, avoid discharging

material against a wall or obstruction which may

cause discharged material to ricochet back toward

the operator.

• Do not mow at high ground speed, especially if a mulch kit

or grass collector is installed.

• For best results it is recommended that the first two laps be

cut with the discharge thrown towards the center. After the

first two laps, reverse the direction to throw the discharge

to the outside for the balance of cutting. This will give a

better appearance to the lawn.

• Do not cut the grass too short. Short grass invites weed

growth and yellows quickly in dry weather.

• Mowing should always be done with the engine at full throttle.

• Under heavier conditions it may be necessary to go back

over the cut area a second time to get a clean cut.

• Do NOT attempt to mow heavy brush and weeds and

extremely tall grass. Your tractor is designed to mow lawns,

NOT clear brush.

• Keep the blades sharp and replace the blades when worn.

Refer to Cutting Blades in the Service section of this manual

for proper blade sharpening instructions.

Mulching

Select models come equipped with a mulch kit which

incorporates special blades, already standard on the tractor, in a

process of recirculating grass clippings repeatedly beneath the

cutting deck. The ultra-fine clippings are then forced back into

the lawn where they act as a natural fertilizer.

Observe the following points for the best results when mulching:

• Never attempt to mulch if the lawn is damp. Wet grass

tends to stick to the underside of the cutting deck

preventing proper mulching of the clippings.

• Do NOT attempt to mulch more than 1/3 the total height of

the grass or approximately 1-1/2 inches. Doing so will cause

the clippings to clump up beneath the deck and not be

mulched effectively.

• Maintain a slow ground speed to allow the grass clippings

more time to effectively be mulched.

• Always position the throttle control lever in the FAST

(rabbit) position and allow it to remain there while mowing.

Failing to keep the engine at full throttle places strain

on the tractor’s engine and does not allow the blades to

properly mulch grass. Ground speed should be controlled

using the speed control lever.

NOTE: It is not necessary to remove the discharge chute to

operate the mower with the mulch kit installed.

WARNING! Never operate the mower without the

discharge chute properly attached.

To operate the cutting deck without mulching, simply remove

the mulch plug. On 38” deck, unthread the plastic wing nut

which fastens it to the cutting deck, as shown in Figure 5-2. This

will allow the clippings to discharge out the side.

Figure 5-2

Note: If your rider is not equipped with a mulch kit, one can be

purchased. See the Attachments & Accessories section of this

manual for more information.

Headlights

• On some models, the lamps are ON whenever the tractor’s

engine is running. On other models, the lamps are ON

whenever the ignition key is moved into the lights position,

with the engine running.

• On all models, the lamps turn OFF when the ignition key is

moved to the STOP position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yard Machines TRACTOR 42SD 1650S 5STY - 13AN775S000 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info