669800
32
Zoom out
Zoom in
Vorherige Seite
1/39
Nächste Seite
CHARGING THE BATTERY
Connect the Power Connector and Balancing Connector to the charger.
STEP 1) BATT/PROGRAM Select.
Press INC and DEC to go through all the programs and press START/ENTER to enter
Li-Io BATT Program.
STEP 2) Mode Select
Press INC and DEC to go through all the modes and press START/ENTER to enter Li-Io
Balance Charge Mode.
STEP 3) Battery Setting
Press START/ENTER, the current value will start to blink, then press INC or DEC to
increase or decrease the value. After confirming your setting, press START/ENTER. For
the Proaction™ battery, it is recommended to set 1.8A (no more than 2A).
The battery cells number will start blinking, press INC and DEC to increase or decrease
the value, and then press START/ENTER to confirm your setting. For the ProAction™,
4S should be selected.
STEP 4) Program Start
Press and hold START/ENTER for 3 seconds to start the program. The charger is
detecting the battery cell and "BATTERY CHECK" will be on the screen
(the third block) R shows the number of cells detected by the charger and S is the
number of cells set by you at the previous screen. If the numbers are not identical,
press STOP to go back to the previous screen to recheck the number of cells of the
battery pack before proceeding the next step.
(the fourth block) R shows the number of cells detected by the charger and S is the
number of cells set by you at the previous screen. If the numbers are identical, press
START/ENTER to start charging. It will take approximately 2 hours to charge a fully
discharged (not over-discharged) battery. When the charging process finishes, "END:
FINISH" will be on the screen.
STEP 5) Charging Status Monitor
During charge process, real-time status will be shown as the left screen.
During the charging process, press STOP to stop the charging process.
31
32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yuneec Tornado H920 Industry wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info